Checking the Alignment of the Running Belt
Proper belt alignment allows the belt to remain centered and ensures smooth operation. Realigning the belt takes a few simple adjustments. If you are unsure about this procedure, call Precor Customer Support. Refer to Obtaining Service.
CAUTION: Special care must be taken when aligning the running belt. Turn OFF the treadmill while adjusting or working near the rear roller. Remove any loose clothing and tie back your hair. Be very careful to keep your fingers and any other object clear of the belt and rollers, especially in front of the roller and behind the deck. The treadmill will not stop immediately if an object becomes caught in the belt or rollers.
1.Turn the unit ON.
2.Stand beside the treadmill and press QUICKSTART.
3.If needed, enter the password by pressing the following keys in sequence: INCLINE ▼, SPEED ▼, SPEED ▲.
The running belt starts automatically after a
4.Press the SPEED ▲ key until the display shows a speed of 3 mph (5 kph).
CAUTION: If you hear any chafing or the running belt appears to be getting damaged, stop the running belt immediately by pressing the red STOP button. Contact Precor Customer Support.
5.Walk around to the rear of the unit and observe the belt for a few minutes. The belt should run centered along the running bed. If the belt drifts off center, you must make adjustments.
Important: If the belt needs alignment, make the adjustments at once. Failure to align the belt may cause the belt to tear or fray, which is not covered by the Precor Limited Warranty.
6.To stop the running belt, press the red STOP button.
7.Turn the treadmill OFF.
Note: Instructions in the Product Owner’s Manual explain how to adjust the running belt.
Commercial Treadmill Assembly Guide | 10 |