C O M M E R C I A L P R O D U C T S D I V I S I O N
8.Attach the left side upright support to the base assembly. Refer to Diagram 6. Align the upright support with the base assembly mounting bracket and secure it by following steps 7a and 7b.
Diagram 7 | Install the |
| display console. |
Display console
Display console mounting brackets
Upright support
9.Secure the display console to the upright supports. Diagram 7.
a.Make sure that the cable is routed through the top of the upright support. Have an assistant hold onto the cable (see inset).
Diagram 8 | Secure the | 1 |
| display console. | |
| CSAFE |
|
| receptacle |
|
| Cable receptacle |
|
| Display console | 2 |
|
| |
| with washers (D) |
|
| Tighten the |
|
| screws, but | 3 |
| leave room for | |
| adjustments. |
|
b.Align the display console with the upright support mounts. Insert two
c.Attach the cable connector by sliding it into its receptacle underneath the con- sole. A definite “click” is heard when the cable is properly attached. Refer to Dia- gram 8, #2.If you do not hear and feel the connector “snap” into place, reinsert it. Important: Do not use the receptacle covered by the plastic plug. This CSAFE receptacle is for a separate option.
d.So that the cable does not hang below the console, slide it into the clip found underneath the console. Refer to Diagram 8, #3.
page 14