Precor C934 owner manual Second

C O M M E R C I A L		P R O D U C T S	D I V I S I O N
Diagram 15	Secure the
	fasteners.
	Second:
	Alternately	2
	tighten four side
	upright screws.
	First: Alternately
	tighten four front		3
	panel screws.
	Third: Alternately
	tighten the four
	screws that	1
	secure the
	console to the
	uprights.

17.Tighten all mounting screws with the hex key (H) provided. Diagram 15. Start at the front of the treadmill with the four screws that attach the upright supports to the front panel. See Diagram 15, #1. Tightening these screws first helps pull the rest of the treadmill’s parts into alignment. Second, proceed with tightening the four screws (A) that secure the upright supports. See Diagram 15, #2. Third, tighten the four console assembly screws (C). See Diagram 3, #3.

Important: For proper alignment, it is critical that the fasteners are tightened in the order shown in Diagram 15.

Diagram 16	Tighten the	1	2
	handrail
	fasteners.
	Handrail clamp
	screws
	Side bracket
			3
	Lower handrail
	screws

18.Tighten all the handrail mounting screws. Diagram 16. So that you don’t overtighten the fasteners, hold the supplied hex key by its 3-inch section and tighten all six handrail clamp screws. Next, tighten the two side bracket screws. Because of inaccessibility, hold the 10-inch section of the hex key to tighten the four lower handrail screws.

page 19