C O M M E R C I A L P R O D U C T S D I V I S I O N
VIEWING THE ODOMETER, HOURS OF USE, SOFTWARE VERSION AND ERROR LOG
While the Precor banner is being displayed, press:
Stop, ENTER, QUICKSTART
Note:You need to press ENTER within ¹⁄₃ second after pressing the Stop button to initiate the Club Custom mode. (The RESET key may be used in place of the Stop button.)
The field name Odometer appears briefly and then the odometer value (the cumula- tive miles or kilometers users have travelled) appears. When either Select key is pressed the word “MILES” (or “KILOMETERS”) appears on the display to let you know the unit of measure.When the key is released, the odometer value reappears.
Press ENTER and the number of hours (Hour Meter) that the unit has been in use appears. The C934 notes the passing of minutes, but the numeric value that appears is truncated to the nearest full hour. When either SELECT key is pressed the word “HOURS appears on the display. When the key is released, the hour meter reappears.
Press ENTER and the unit’s three digit SW Version (upper display software version number) appears. Press either SELECT key to view the lower board’s software version number. The SELECT key toggles between the two versions. The words “UPPER” and “LOWER” appear prior to the version being displayed.
Press ENTER or the red Stop button and the Error Log appears. Press any ▼ or
▲key to scroll through the error codes. Up to ten error codes can be recorded and retrieved.
To view the odometer reading at the time the error was detected and the hours of use at the time the error occurred, press either SELECT key while the error code is being displayed. The SELECT keys act as toggles between the associated information.
Note: To clear (delete) the error log, press QUICKSTART for at least four seconds while viewing the list. Prompts appear on the display and let you know when the error messages have been deleted (“cleared” from memory).
Important: You cannot retrieve the error log once you have deleted it.
To return to the Precor banner, press RESET, ENTER or the red Stop button.
page 26