Huffy LDF6920 manual Section a Assemble the Base

Page 10

SECTION A: ASSEMBLE THE BASE

This is what your system will look like when you’ve finished this section:

TOOLS REQUIRED FOR THIS SECTION

(2) 1/2” and (2) 9/16” Wrenches

(2) Socket Wrenches and Sockets

AND/OR

1/2” 9/16”

Item #21 (2)

ID# M7301241

04/06

10

Image 10

Contents Portable System Before YOU Start Failure to Follow These Safety Instructions Warranty Card Front Parts List See Hardware Identifier Hardware Identifier Bolts Hardware Identifier Washers Section a Assemble the Base Correctly identify each pole section as labeled Do not Over Tighten 04/06 ID# M7301241 Curve of the washer 14 should match the curve of the pole 04/06 ID# M7301241 Pole Needs to Face in the Position Referenced Here Section B Attach the Backboard Orientation Stop Tightening NUT 32 When Flush with END of the Bolt FIG a Nut 32 as shown Install Slam Jam Rim to Backboard Section C Apply Height and Moving Label & Securing System Système portable Manuel dutilisation Outils ET Matériel Requis Stop Warnung Consignes DE Sécurité Avis AUX Personnes Chargées DU Montage Avant Vorderseite Parte Frontal Liste DES Pièces Voir légende #22 #21 #33 #21 04/06 ID# M7301241 Wichtig ¡IMPORTANTE Remarque Remarque Hinweis Nota Remarque Hinweis Nota Wichtig ¡IMPORTANTE ET/OU UND/ODER OET UND Wichtig ¡IMPORTANTE 04/06 ID# M7301241 IMPORTANT! / WICHTIG! / ¡IMPORTANTE FIG a IMPORTANT! / WICHTIG! / ¡IMPORTANTE Avertissement Warnung ¡ADVERTENCIA Installez le cerceau Slam Jam sur le panneau ID# Avertissement Warnung ¡ADVERTENCIA Vorsicht ¡PRECAUCIÓN