Huffy LDF6920 manual Pole Needs to Face in the Position Referenced Here

Page 16

8. Support pole on sawhorse. Attach upper section of pole (5) to middle section of pole (6) using bolts (17), washers (14), and nuts (16) as shown.

6

17

14

14

17

16

14

14

16

NOTE:

You may need to LIGHTLY tap end of pole to align holes. Use wood scrap and hammer (not supplied).

5

IMPORTANT!

THE POLE NEEDS TO FACE IN THE POSITION REFERENCED HERE.

ID# M7301241

04/06

16

Image 16
Contents Portable System Before YOU Start Failure to Follow These Safety Instructions Warranty Card Front Parts List See Hardware Identifier Hardware Identifier Bolts Hardware Identifier Washers Section a Assemble the Base Correctly identify each pole section as labeled Do not Over Tighten 04/06 ID# M7301241 Curve of the washer 14 should match the curve of the pole 04/06 ID# M7301241 Pole Needs to Face in the Position Referenced Here Section B Attach the Backboard Orientation Stop Tightening NUT 32 When Flush with END of the Bolt FIG a Nut 32 as shown Install Slam Jam Rim to Backboard Section C Apply Height and Moving Label & Securing System Système portable Manuel dutilisation Outils ET Matériel Requis Stop Warnung Consignes DE Sécurité Avis AUX Personnes Chargées DU Montage Avant Vorderseite Parte Frontal Liste DES Pièces Voir légende #22 #21 #33 #21 04/06 ID# M7301241 Wichtig ¡IMPORTANTE Remarque Remarque Hinweis Nota Remarque Hinweis Nota Wichtig ¡IMPORTANTE ET/OU UND/ODER OET UND Wichtig ¡IMPORTANTE 04/06 ID# M7301241 IMPORTANT! / WICHTIG! / ¡IMPORTANTE FIG a IMPORTANT! / WICHTIG! / ¡IMPORTANTE Avertissement Warnung ¡ADVERTENCIA Installez le cerceau Slam Jam sur le panneau ID# Avertissement Warnung ¡ADVERTENCIA Vorsicht ¡PRECAUCIÓN