Huffy LDF6920 manual Orientation

Page 18

1.

Place backboard brackets (25) inbetween backboard struts as shown.

25

NOTE

ORIENTATION

25

2. Assemble backboard brackets (25) using bolts (22), and nuts (12) as shown.

12

12

22

22

NOTE

ORIENTATION

25

IMPORTANT!

Test fit bolts into holes of backboard brackets (29) and carefully rock them in a circular motion to ream out paint from holes if necessary.

ID# M7301241

04/06

18

Image 18
Contents Portable System Before YOU Start Failure to Follow These Safety Instructions Warranty Card Front Parts List See Hardware Identifier Hardware Identifier Bolts Hardware Identifier Washers Section a Assemble the Base Correctly identify each pole section as labeled Do not Over Tighten 04/06 ID# M7301241 Curve of the washer 14 should match the curve of the pole 04/06 ID# M7301241 Pole Needs to Face in the Position Referenced Here Section B Attach the Backboard Orientation Stop Tightening NUT 32 When Flush with END of the Bolt FIG a Nut 32 as shown Install Slam Jam Rim to Backboard Section C Apply Height and Moving Label & Securing System Système portable Manuel dutilisation Outils ET Matériel Requis Stop Warnung Consignes DE Sécurité Avis AUX Personnes Chargées DU Montage Avant Vorderseite Parte Frontal Liste DES Pièces Voir légende #22 #21 #33 #21 04/06 ID# M7301241 Wichtig ¡IMPORTANTE Remarque Remarque Hinweis Nota Remarque Hinweis Nota Wichtig ¡IMPORTANTE ET/OU UND/ODER OET UND Wichtig ¡IMPORTANTE 04/06 ID# M7301241 IMPORTANT! / WICHTIG! / ¡IMPORTANTE FIG a IMPORTANT! / WICHTIG! / ¡IMPORTANTE Avertissement Warnung ¡ADVERTENCIA Installez le cerceau Slam Jam sur le panneau ID# Avertissement Warnung ¡ADVERTENCIA Vorsicht ¡PRECAUCIÓN