Huffy LDF6920 manual Section C Apply Height and Moving Label & Securing System

SECTION C: APPLY HEIGHT AND MOVING LABEL & SECURING SYSTEM

1. Carefully upright assembly. Apply moving system label (23) to front of pole as shown. Regulation

rim height is 10 feet (3.05 m).
			WARNING!
			TWO PEOPLE REQUIRED FOR
			THIS PROCEDURE. FAILURE
			TO FOLLOW THIS WARNING
		23	COULD RESULT IN SERIOUS
			INJURY AND/OR PROPERTY
			DAMAGE.
	HEIGHT ADJUSTMENT		WARNING!
	TO ADJUST BACKBOARD:
	1. TO RAISE BACKBOARD:
	Slowly push up on the rim with broom		DO NOT LEAVE ASSEMBLY
	handle or wooden dowel,
	3/4”- 7/8” (19mm - 22mm) diameter
	as shown to engage locking	LEVER	UNATTENDED WHEN EMPTY; IT
	mechanism at desired height.	1
	2. TO LOWER BACKBOARD:		MAY TIP OVER.
	Push lever up to unlock and	2
	carefully lower backboard to lowest	BROOM
10 ft.	position.	HANDLE
	MOVING SYSTEM		WARNING!
(3.05 m)
	1.	Adjust basketball backboard
23	1	height to lowest position.
	2.	While holding pole, rotate	DO NOT ALLOW CHILDREN TO
		until wheels engage with
		basketball system forward
		ground.	ADJUST HEIGHT.
	3.	Move basketball system to
	2	desired location.
	4.	Carefully rotate basketball	CAUTION!
	3	system upright.
	4
	5. Reattach ground restraint and
		check system for stability.

201257 3/99

ADD TWO GALLONS (7.6

LITERS) OF NON-TOXIC

ANTIFREEZE IN

SUB-FREEZING CLIMATES.

NOTE:

NOTE:

Peel protective

film from surface

of acrylic

backboard prior

to use.

Sand	lb	.	kg)
300
(163

IF USING SAND: 2 GALLONS OF ANTI-FREEZE IS NOT REQUIRED

2. Place assembled unit in desired location. Fill tank with water (30 gallons/114 liters) or sand (300 lb./136 kg) and snap tank cap (4) in place.

4

4

23 04/06 ID# M7301241