Huffy LDF6920 manual Install Slam Jam Rim to Backboard

Page 22

10.	Install Slam Jam Rim to Backboard

AFit rim (39) securely into bracket (37) as shown. Allow T-bolt (36) to slip through center hole in rim (39).

BInstall reinforcement bracket (40) onto T-bolt (36) as shown.

CInstall spring (41) onto T-bolt (36) as shown.

DInstall special nut (43) and washer (42) onto T-bolt (36).

E Tighten nut (43) until flush with end of T-bolt (36).

B

A

39

36

37

CD

41

36

40

36

43

42

		E	36	42
			43
ID#	M7301241	04/06		22

Image 22

Contents Portable System Before YOU Start Failure to Follow These Safety Instructions Warranty Card Front Parts List See Hardware Identifier Hardware Identifier Bolts Hardware Identifier Washers Section a Assemble the Base Correctly identify each pole section as labeled Do not Over Tighten 04/06 ID# M7301241 Curve of the washer 14 should match the curve of the pole 04/06 ID# M7301241 Pole Needs to Face in the Position Referenced Here Section B Attach the Backboard Orientation Stop Tightening NUT 32 When Flush with END of the Bolt FIG a Nut 32 as shown Install Slam Jam Rim to Backboard Section C Apply Height and Moving Label & Securing System Système portable Manuel dutilisation Outils ET Matériel Requis Stop Warnung Consignes DE Sécurité Avis AUX Personnes Chargées DU Montage Avant Vorderseite Parte Frontal Liste DES Pièces Voir légende #22 #21 #33 #21 04/06 ID# M7301241 Wichtig ¡IMPORTANTE Remarque Remarque Hinweis Nota Remarque Hinweis Nota Wichtig ¡IMPORTANTE ET/OU UND/ODER OET UND Wichtig ¡IMPORTANTE 04/06 ID# M7301241 IMPORTANT! / WICHTIG! / ¡IMPORTANTE FIG a IMPORTANT! / WICHTIG! / ¡IMPORTANTE Avertissement Warnung ¡ADVERTENCIA Installez le cerceau Slam Jam sur le panneau ID# Avertissement Warnung ¡ADVERTENCIA Vorsicht ¡PRECAUCIÓN