Huffy LDF6920 manual 04/06 ID# M7301241

Page 13

4. Attach middle section of pole (6) onto bottom section of pole (7). Align holes in middle pole (6) with hole pattern on bottom pole (7).

6

7

5. Secure struts (15) to poles by using bolt (17) & sleeve nut (16) with supplied allen wrenchs (21) as shown.

17

NOTE:

You may need to LIGHTLY tap end of pole to align holes. Use wood scrap and hammer (not supplied).

16

15

15

13

04/06

ID# M7301241

Image 13

Contents Portable System Before YOU Start Failure to Follow These Safety Instructions Warranty Card Front Parts List See Hardware Identifier Hardware Identifier Bolts Hardware Identifier Washers Section a Assemble the Base Correctly identify each pole section as labeled Do not Over Tighten 04/06 ID# M7301241 Curve of the washer 14 should match the curve of the pole 04/06 ID# M7301241 Pole Needs to Face in the Position Referenced Here Section B Attach the Backboard Orientation Stop Tightening NUT 32 When Flush with END of the Bolt FIG a Nut 32 as shown Install Slam Jam Rim to Backboard Section C Apply Height and Moving Label & Securing System Système portable Manuel dutilisation Outils ET Matériel Requis Stop Warnung Consignes DE Sécurité Avis AUX Personnes Chargées DU Montage Avant Vorderseite Parte Frontal Liste DES Pièces Voir légende #22 #21 #33 #21 04/06 ID# M7301241 Wichtig ¡IMPORTANTE Remarque Remarque Hinweis Nota Remarque Hinweis Nota Wichtig ¡IMPORTANTE ET/OU UND/ODER OET UND Wichtig ¡IMPORTANTE 04/06 ID# M7301241 IMPORTANT! / WICHTIG! / ¡IMPORTANTE FIG a IMPORTANT! / WICHTIG! / ¡IMPORTANTE Avertissement Warnung ¡ADVERTENCIA Installez le cerceau Slam Jam sur le panneau ID# Avertissement Warnung ¡ADVERTENCIA Vorsicht ¡PRECAUCIÓN