Miele T4819Ci operating instructions Problem solving guide, Check and fault messages

Problem solving guide

With the help of the following notes minor faults in the performance of the appliance, some of which may result from incorrect operation, can be put right without contacting the Service Department.

￿Repair work to electrical appliances should only be carried out by a suitably qualified person in strict accordance with current local and national safety regulations. Repairs and other work by unqualified persons could be dangerous. The manufacturer cannot be held liable for unauthorised work.

Check and fault messages

Problem	Possible cause	Remedy
0-§appears in	The electronic system lock is	You will need to deactivate
the display.	activated.	the system lock before the
The Low		dryer can be used (see
temperature		"Electronic system lock").
indicator light is
flashing.
The programme	This is not a fault.	Use the Warm air
stops and	The electronic unit has	programme for drying
0 and Finish	recognised that there is no	individual items.
appear in the	laundry or insufficient laundry	– Open and shut the door.
display.	in the drum and cancelled the
The buzzer	programme. Drying individual
sounds.	garments or items which are
	already dry can also cause the
	programme to be cancelled.
The programme	No obvious cause.	– Switch the dryer off and
stops.		back on again.
The buzzer		– Then start the programme
sounds.		again.
Cooling down or		If this problem happens
Finish may also		again, there is a fault.
flash in the		Contact Miele.
display.
Bars are	The programme has finished	You can either unload the
flashing at the	but the laundry is still being	drum and leave the laundry
end of the	cooled down.	to cool at room temperature
programme:		or leave it in the dryer to
—œ–...C~–...Cœ˜...		continue cooling.

33