Installation
Fitting a door front panel made by another manufacturer
Preparing the front panel
Measure distance X for drilling the hinge holes.
– with spacer bars:
– without spacer bars:
(the front panel must be correspondingly higher)
Mark the two hinge holes and the four smaller holes as shown in the diagram.
Depending on country, this tumble dryer is supplied either left or right hand hinged.
For left hand hinging only:
–front panel shown decor side face down, upper edge at the bottom:
if width (b) increases, measurement a must also be increased
b = 592 mm a = 21.5 mm b = 593 mm a = 22.0 mm b = 594 mm a = 22.5 mm b = 595 mm a = 23.0 mm b = 596 mm a = 23.5 mm
H = height of adjacent furniture unit doors.
46