Miele T4819Ci External condensed water outlet, General notes, Arranging the drain hose

Installation

External condensed water outlet

General notes

When drying is in progress, condensed water is pumped into the condensed water container through the drain hose at the back of the dryer. The condensed water can also be drained off directly if the dryer is installed near a sink, drain outlet etc. so that the condensed water container does not have to be emptied.

Drain hose length . . . . . . . . . . . . 1.00 m

Extension hose . . . . . . . . . . . . . . 2.00 m (accessory)

Maximum delivery head . . . . . . . 1.50 m

Maximum drain hose length . . . . 4.00 m

￿If the on-site water drainage system is not fitted with a non-return valve or an appropriate air gap, an air gap or the non-return valve supplied with the dryer must be fitted to prevent the risk of back-flow. (See "Installation conditions requiring a non-return valve").

Maximum delivery head

with non-return valve fitted . . . . . 1.00 m

Arranging the drain hose

￿Do not pull on the drain hose and do not stretch it or allow it to become kinked as it could get damaged.

￿Unclip the drain hose from clips (1) and (2).

￿Then pull it off connection (3).

￿The lower clip (4) can be opened to allow you to take the drain hose out or to feed the mains cable through it.

49