Quick Check
After replacing any part in the unit you can do a quick check to make sure that the unit is working normal by following the procedure below:
•Checking Wash cycle - Set the washer knob to the Towels/Sheets position and press the Power button, the unit will start filling in with water from both the inlet valves, after a few minutes the unit stops to fill and the drum will start to agitate. Then press the Power button, advance the knob to the Spin position and press the power button the unit will pump out the water and begin to spin simultaneously.
•Checking Dry cycle – Set the washer knob to the off position (End of the green marking) and set a drying cycle for 30’. The unit will start heating up and you can sense hot air in the drum.
ePlease Note: In this unit the door cannot be opened in the washing cycle unless and until the washer knob comes to the Off position, however the door can be opened at any time during the drying cycle.
********
29