Equator MD3720CEE service manual Important Preservice Instructions

Page 6

IMPORTANT PRESERVICE INSTRUCTIONS

It is advisable for anyone to go through the following points before one actually works

on the unit.

Shipping bolts: The unit is shipped with 3 shipping bolts and spacers to avoid any damage to the unit during shipping. Make sure that all the shipping bolts and the spacers have been removed from the unit.

Height of drain hose: The drain hose should be placed in such a way that the height of the drain hose does not exceed 36” and is not lower than 28” inches from the bottom of the unit.

Water inlets: In this unit two water inlets are required to be connected for hot as well as for cold water. Make sure that water supply is provided to both the inlets. In case hot water supply is not available cold water supply should be connected to the hot water inlet valve.

Leveling: The unit must be leveled properly for proper working of the unit.

Flooring: The unit should be installed on strong and leveled floor, installation on carpet or wood increases vibrations. For better working of the unit, the unit should be installed on a thin carpet and in case of wooden flooring, proper bracings should be made and the unit should be installed on a sheet of plywood.

Please note: All the above instructions are mentioned in the Owners Manual and if the unit is found to be malfunctioning due to any of the above points not been taken care of, the customer will be liable to pay for the complete service call along with the parts. If the customer is not willing to pay for the service we will be paying for the same but the customers warranty will be voided then.

6

Image 6
Contents Combo Washer Dryer # Table of Contents # Warranty Information Safe Servicing Practices Installation MD 3720 CEE Important Preservice Instructions Machine vibrating or vibrating noise Water leaking from doorUnit wont fill Unit is noisy Unit fills, won’t agitate / tumbleUnit won’t drain out water Unit VibratesWater fill in tub with unit off Timer doesn’t advanceWater leaks from detergent drawer Unit overfillsNo tumble action Unit keeps filling only when the unit is switched onClothes wet at the end of wash cycle Clothes cold and damp at the end of dry cycleClothes hot and damp at the end of dry cycle Long Drying TimeReplacement Procedure, Wiring & Testing of Parts Power Switch 52799 Replacement ProcedureDoor Switch / Door Lock 00750 Replacement Procedure Pressure Switch 50774 Replacement Procedure Cold water valve 10820 Replacement Procedure Hot TestHot water valve 00821 Replacement Procedure Wash Timer 50819 Replacement Procedure Dry Timer 50728 Replacement Procedure Cold TestHalf Load Switch 51799 Replacement Procedure Half Heat Switch 50799 Replacement Procedure Fusible Link / Wire with fuse 00807 Replacement Procedure Wiring Fusible LinkThermostat 00808 Replacement Procedure FEXFan Motor 50732 Replacement Procedure Blower / Fan / Impeller Assembly 51733 Replacement Procedure Heating Element 00745 Replacement Procedure Speed Regulator 00791 Replacement Procedure Drain Pump 00776 Replacement Procedure Main Motor 50751 Replacement Procedure Quick Check Appliance Desk