Equator MD3720CEE Water leaks from detergent drawer, Timer doesn’t advance, Unit overfills

Page 9

b)Unstable floor: Remove carpeting, move to another location, or install underlayment.

c)Unit not leveled properly: Adjust leveling legs, tighten lock nuts.

d)Drum not leveled: If vibration persists then open the top cover and see if the drum is leveled up. If not the position of the springs holding the drum may have to be adjusted or else replace the springs.

6) Water leaks from detergent drawer

a)Unit not leveled: Adjust leveling legs, tighten lock nuts.

b)Spinning with water in tub: Not draining. See Won't drain.

7) Timer doesn’t advance

a)Water supply off: Check water pressure at inlet valve connections.

b)Filling interrupted: See Won't Fill.

c)Timer Knob: If the timer knob is having some friction with the panel it won’t allow the wash timer to advance. Pull out the timer knob and run a cycle to check if the timer is advancing.

d)Wash Timer: Test wash timer motor resistance: 2000 ohms max. Set to different cycle (e.g. Delicates) & check timer function different cycle (e.g. Delicates). If the timer still does not advance the timer is bad.

8) Water fill in tub with unit off

a)Water inlet valves leaking: Identify leaking valve. Remove and clean by back flushing to remove foreign material. Replace valve if cleaning does not correct the problem.

9) Unit overfills

a)Pressure Switch: Unplug unit. With excessive water still in tub, check for continuity between terminals 31 and 32. Replace pressure switch if test indicates continuity.

b)Pressure Switch Hose: Drain machine, then replace kinked or leaking pressure switch hose. There may also have been some blockage in the pressure switch hose or the air trap, remove the blockage if any.

10) Door won’t open

a)Door lock enabled: Water in tub. See Won't drain.

b)Door Switch: Unplug the unit and turn wash timer knob to off position. Wait two minutes for door switch to unlock. Door should open now. If not the door switch latch is mechanically stuck. Put one hand behind the door switch and push the metallic plate (latch) forward towards the drum, simultaneously trying to open the door with the other hand. Replace the door switch.

11)Unit won’t spin in cycles: Pre wash /Heavy / Towels/sheets /Active wear / Easy care

a)Motor: See Testing of motor.

b)Speed Regulator / Wash Timer: Set the wash timer to the position one click away from the off position for the Easy care cycle. Check the continuity between terminal#1 on Speed

9

Image 9
Contents Combo Washer Dryer # Table of Contents # Warranty Information Safe Servicing Practices Installation MD 3720 CEE Important Preservice Instructions Machine vibrating or vibrating noise Water leaking from doorUnit wont fill Unit won’t drain out water Unit fills, won’t agitate / tumbleUnit is noisy Unit VibratesWater leaks from detergent drawer Timer doesn’t advanceWater fill in tub with unit off Unit overfillsClothes wet at the end of wash cycle Unit keeps filling only when the unit is switched onNo tumble action Clothes cold and damp at the end of dry cycleLong Drying Time Clothes hot and damp at the end of dry cyclePower Switch 52799 Replacement Procedure Replacement Procedure, Wiring & Testing of PartsDoor Switch / Door Lock 00750 Replacement Procedure Pressure Switch 50774 Replacement Procedure Hot Test Cold water valve 10820 Replacement ProcedureHot water valve 00821 Replacement Procedure Wash Timer 50819 Replacement Procedure Cold Test Dry Timer 50728 Replacement ProcedureHalf Load Switch 51799 Replacement Procedure Half Heat Switch 50799 Replacement Procedure Wiring Fusible Link Fusible Link / Wire with fuse 00807 Replacement ProcedureFEX Thermostat 00808 Replacement ProcedureFan Motor 50732 Replacement Procedure Blower / Fan / Impeller Assembly 51733 Replacement Procedure Heating Element 00745 Replacement Procedure Speed Regulator 00791 Replacement Procedure Drain Pump 00776 Replacement Procedure Main Motor 50751 Replacement Procedure Quick Check Appliance Desk