English
Steps for the Wash Process
1.Turn the power ON by pressing the “ON” button.
2.Press “Cycle Select”to select wash program.
3.Select the water level.
4.Add the detergent.
5.Add the wash load.
6.Press the Start / Pause button.
7.After the washing machine starts, you may change the cylcle or program by turning OFF the machine and then restarting to make the new selection.
Note: If the washer is turned ON without any water in the tub, it will start to spin after a few minutes. The pulsator will not rotate unless the water is filled to a selected level.
Note: Do not use the “HEAVY Wash” program for woolen clothing.
Note: Loading the Washer
•Load each item loosely.
•Separate the white from the colored clothing. Separate heavy fabrics from light fabrics.
•Carefully check all pockets and cuffs for foreign items. They can easily slide into the tub and cause damage to the tub and/or make disturbing noises during cycles.
•Always balance the laundry load evenly within the washer tub, so there is no single heavy areas and all the laundry is evenly distributed.
Note: There is a filter in the water inlet valve. This prevents foreign particles in the water from entering the washer. Clean this at least once a month.
Selecting the Water Level
• There are 3
.
Your selection may depend on your wash load
WATER
HIGH LEVEL
MEDIUM 
LOW
16