Frigidaire 137134900B important safety instructions Electrical connection non-Canada 4 wire cord

INSTALLATION INSTRUCTIONS

Electrical connection (non-Canada) - 4 wire cord

4-wire receptacle

(NEMA type 14-30R)

WARNING

ELECTRICAL SHOCK HAZARD Failure to disconnect power source before servicing could result in personal injury or even death.

1	Turn off power supply to outlet.
2	Remove the screw securing the terminal block
	access cover in the lower corner on the back of the
	dryer.
3	Install a UL-approved strain relief according to the
	power cord/strain relief manufacturer’s instructions
	in the power cord entry hole below the access
	panel. At this time, the strain relief should be
	loosely in place.
4	Thread an UNPLUGGED, UL-approved, 30 amp.
	power cord, NEMA 14-30 type ST or SRDT, through
	the strain relief.
5	Disconnect the internal (BLACK) dryer harness
	ground wire from the (GREEN) ground screw next
	to the terminal block.
6	Attach the ground (GREEN) power cord wire to the
	cabinet with the ground (GREEN) screw. Tighten
	the screw securely.
7	Move the internal dryer harness ground (BLACK)
	wire to the terminal block and attach it along with
	the neutral (WHITE) power cord wire conductor
	to the center, SILVER colored terminal on the

		Neutral
30 AMP	Ground	(WHITE wire)
	(GREEN wire)
NEMA 14-30

Access cover

screw

Terminal

block

Line 2

(BRASS terminal)

Neutral

(SILVER terminal)

Line 1

(BRASS terminal)

Internal ground (GREEN screw)

Install

UL-approved

strain relief here

Terminal screw

recovery slot

NOTE

If a terminal screw falls during cord installation, it can be retrieved in the terminal screw recovery slot below the access panel.

terminal block. Tighten the screw securely.

8 Attach the RED and BLACK power cord conductors

to the outer, BRASS colored terminals on the

terminal block. Tighten both screws securely.

WARNING

ELECTRICAL SHOCK HAZARD

Do not make a sharp bend or crimp wiring/conductor at connections.

9Follow manufacturer’s guidelines for firmly securing the strain relief and power cord.

10Reinstall the terminal block cover.

Move internal ground (BLACK)

wire to neutral (SILVER)

terminal for 4-wire system.

GREEN

ground screw

GREEN

ground wire

BLACK or

RED power wire

Neutral terminal

WHITE

neutral wire

BLACK or RED

power wire

16