Options, Location Requirements | Electrolux FKGHS01P manual

Options

Pedestal

Are you placing the dryer on a pedestal? You may purchase a pedestal separately for this dryer. This pedestal will add about 13" (33 cm) to the height of your unit for a total height of approximately 51" (130 cm).

Optional pedestal

To order, call the dealer from whom you purchased your dryer or refer to the “Assistance or Service” section of this manual. Ask for Part Number LAB2700PMT (Meteorite) or LAB2700MQ0 (White).

Stack Kit

Are you planning to stack your washer and dryer? To do so, you will need to purchase a Stack Kit.

To order, call the dealer from whom you purchased your dryer or refer to the “Assistance or Service” section of this manual. Ask for Part Number 8541503.

Location Requirements

WARNING

Explosion Hazard

Keep flammable materials and vapors, such as gasoline, away from dryer.

Place dryer at least 18 inches (46 cm) above the floor for a garage installation.

Failure to do so can result in death, explosion, or fire.

You will need

■A location that allows for proper exhaust installation. A gas dryer must be exhausted to the outdoors. See “Venting Requirements.”

■A grounded electrical outlet located within 2 ft (61 cm) of either side of the dryer. See “Electrical Requirements.”

■A sturdy floor to support the total dryer weight of 200 lbs (90.7 kg). The combined weight of a companion appliance should also be considered.

■A level floor with a maximum slope of 1" (2.5 cm) under entire dryer. If slope is greater than 1" (2.5 cm), install Extended Dryer Feet Kit, Part Number 279810. Clothes may not tumble properly and automatic sensor cycles may not operate correctly if dryer is not level.

■For a garage installation, you will need to place the dryer at least 18" (46 cm) above the floor. If using a pedestal, you will need an additional 6" (15.24 cm).

Do not operate your dryer at temperatures below 45ºF (7ºC). At lower temperatures, the dryer might not shut off at the end of an automatic cycle. This can result in longer drying times.

The dryer must not be installed or stored in an area where it will be exposed to water and/or weather.

Check code requirements. Some codes limit, or do not permit, installation of the dryer in garages, closets, mobile homes, or sleeping quarters. Contact your local building inspector.

NOTE: No other fuel-burning appliance can be installed in the same closet as a dryer.

Installation clearances

■The location must be large enough to fully open the dryer door.

■Additional spacing should be considered for ease of installation and servicing.

■Additional clearances might be required for wall, door and floor moldings.

■Additional spacing of 1" (2.5 cm) on all sides of the dryer is recommended to reduce noise transfer.

■Companion appliance spacing should also be considered.

Dryer Dimensions

51½" (130.81 cm)

38"

(96.52 cm)

*31½"

(80 cm)

27"

(68.6 cm)

*Most installations require a minimum 5½" (14 cm) clearance behind the dryer for the exhaust vent with elbow. See “Venting Requirements.”

Minimum installation spacing for custom undercounter installation

The dimensions shown are for the minimum spacing allowed.

Custom undercounter installation - Dryer only

0" (0 cm)

38" min. (96.52 cm)

0"		27"		0"
(0 cm)		(68.6 cm)	(0 cm)

FKGHS01P specifications

The Electrolux FKGHS01P is a highly regarded kitchen appliance that brings together innovation, design, and functionality. This cooking device is not just a standard kitchen appliance; it epitomizes modern cooking technology, ensuring a seamless culinary experience.

One of the main features of the FKGHS01P is its advanced induction cooking technology. Induction cooktops are known for their quick heating capabilities, and the FKGHS01P excels in this category. Induction cooking works by generating heat directly in the cookware through electromagnetic energy, which can reduce cooking times significantly. This also translates to increased energy efficiency as it wastes less heat than traditional gas or electric cooktops.

The appliance boasts a sleek and contemporary design, which makes it an attractive addition to any kitchen. Its smooth surface is easy to clean, and the minimalistic aesthetic fits well with modern kitchen decor. With intuitive controls, users can easily adjust cooking temperatures and settings, providing a user-friendly cooking experience.

Another standout feature of the Electrolux FKGHS01P is its versatile cooking zones. The induction cooktop includes multiple cooking zones of varying sizes, allowing users to accommodate a range of pot and pan sizes. Whether you're boiling pasta or simmering sauces, there is enough room to cook multiple dishes simultaneously.

Equipped with safety features, the FKGHS01P includes child lock settings and automatic shut-off systems, providing peace of mind for families. Furthermore, the induction technology allows for quick temperature adjustments, enhancing control over cooking processes and reducing the risk of burns or accidents.

In terms of smart technology, the Electrolux FKGHS01P integrates seamlessly with smart home systems, enabling connectivity and convenience. Users can monitor their cooking from a mobile device, receive notifications, and even manage timers remotely.

In summary, the Electrolux FKGHS01P offers a blend of state-of-the-art technology, safety, and sleek design. With its induction cooking capabilities, versatile zones, and smart home integration, it caters to both novice cooks and culinary enthusiasts alike. Its commitment to efficiency and user-friendliness makes it a standout appliance in the contemporary kitchen landscape.