All joints should be tight to avoid leaks. The male end of each duct section must point away from the dryer.
Whether connecting to an existing venting system or a new venting system, make sure that all ducting is clean and free of lint.
The maximum permitted length for
rigid duct and for rigid duct used with flexible metal duct is shown in the table below. If using flexible metal ducting to connect the appliance to the ductwork system, the total length of flexible metal duct used shall not exceed 2.4 m and can only be used to connect the dryer to the ductwork system. As the table below shows, the maximum overall ductwork length is reduced if flexible ducting is used.
Maximum | Ductwork Length |
|
|
|
| |||||||
|
|
|
|
|
|
|
|
|
| |||
Number of |
| Rigid | Duct |
| Flexible | Duct |
|
| ||||
90° | Turns |
|
|
|
|
| in |
|
|
|
|
|
or | Elbows |
|
|
|
|
| Combination |
|
| |||
|
|
|
|
|
|
| with | Rigid |
|
| ||
|
|
|
|
|
|
| Duct |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 0 |
| 66 | ft. |
|
| 45 | ft. |
|
|
|
|
|
|
| (2011 | cm) |
| (1372 | cm) |
|
| |||
| 1 |
| 56 ft. |
|
| 36 | ft. |
|
|
|
| |
|
|
| (1707 | cm) |
| (1097 | cm) |
|
| |||
| 2 |
| 48 ft. |
|
| 29 | ft. |
|
|
|
| |
|
|
| (1463 | cm) |
| (884 cm) |
|
| ||||
| 3 |
| 39 ft. |
|
| 22 | ft. |
|
| Exhaust | vent hood | |
|
|
|
|
|
| The exhaust duct must end with an | ||||||
|
|
| (1189 | cm) |
| (671 cm) | ||||||
| 4 |
| 30 ft. |
|
| 16 | ft. |
|
| approved exhaust vent hood with | ||
|
|
|
|
|
| swing out damper(s). DO NOTuse an | ||||||
|
|
| (914 | cm) |
| (488 cm) | ||||||
|
|
|
| exhaust vent hood with magnetic | ||||||||
|
|
|
|
|
|
|
|
|
|
| ||
Note: |
|
|
|
|
|
|
|
| latches. |
| ||
Side and bottom exhaust installations | To avoid exhaust restriction, the outlet | |||||||||||
have a 90° turn inside | the Takedryr. | must be | a minimum of 12 inches (30 | |||||||||
this into account when using the table cm) above ground level or any other
above. | obstructing surface. |
More than two 90turns° are not recommended. For best performance, separate all turns by at least 4 ft. of straight duct, including distance between last turn and exhaust hood.
Required Ductwork Parts
The parts required for the exhaust air system (elbows, lines, exhaust air outlets) are not included in standard delivery of the dryer (see the Accessories section for information on ordering parts.)
Professional installation of ductwork is recommended.
14