Bosch Appliances Nexxt Series manual AQUASTOP Hose, Water Connection, External

- Benefits of maintaining greater distance (clearances) than the minimum shown include:

The size of the installation area depends on the dimensions of the dryer. Ensure that there is adequate room for the swivel range of the door!

AQUASTOP Hose

S reduction of the risk of mold					NOTICE
	formation behind the appliance.
			Properly secured				EXTERNAL hose
S	reduced noise	transmission		connections		are	the	sole
S	facilitation of installation and			responsibility		of	the	customer. The
				manufacturer		assumes			no
	service.
				responsibilty		or liability			for
S	more air cools	the dryer, keeps
				improperly installed				EXTERNAL
	the dryer from overheating,		andhose or other connections.
	improves	drying performance.

-If the dryer is installed in a small room, the doors of the room must be fitted with vents of a specified minimum size. Refer to the following figure for additional information.

	Dimension			Weight
a	27.0"	(686	mm)	125	lbs
b	31.8"	(808	mm)	(56	kg)
				with
c	37.2"	(945	mm)
				packaging
d	19.7"	(500 mm)/		143	lbs
				(64	kg)
angle	170	- 180°

If installing the dryer in a closet, observe the minimum distances according to

the following table:

Minimum Installation Clearances

The AQUASTOP Hose prevents potential flooding if the hose leaks.

If the hose leaks, a red mark is displayed and the water inlet is blocked.

qAn AQUASTOP Hose that has activated cannot be reset. Contact Customer Service for a replacement hose (see page 26).

MISTCAREt Dryer Parts Supplied

Closet

The

following

parts are included with

Sides

0"

(O

mm)

the

shipment

of your dryer.

Top

12"

(3O5 mm)

Rear*

0"

(O

mm)

1

The

dryer

door is

delivered

with hinges

* as

close

to

wall as venting or water

connection

will

allow.

on

the

right.

2

Important

information concerning

If the door hinge is to be changed over

to the

left

see page 15.

minimum

distances:

3

-

Depending

on the

location

of the

Water Connection

exhaust

air

connection,

an

Attach

the

dryer

water

supply

hose

to

a

additional

minimum

distance

of

5½ inch

(14 cm)

must

be

cold

water

faucet

(the

faucet

must

be

provided

within

4

ft

(1.2

m)

of

the

water

located

on this side for ducts/brackets (see

4

page

15).

inlet

valve

on

the

back

of

the dryer).

It is recommended to have a water

supply

pressure of

20 - 100 psi (1.37 -

6.89 bar)

for

best

performance.

A •Y•

connector

is provided

along

with

a short hose (if needed) in order to

connect

it

to

the

cold

water

faucet.

8