Furuno SC-50 WAAS/DGPS Setup, WAAS/DGPS menu, Position fix mode options, Waas Search options

Page 47

3. OPERATION

3.10WAAS/DGPS Setup

1.Press the [MENU] key to open the menu.

2.Choose WAAS/DGPS and then press the [ENT] key.

WAAS/DGPS

MODE

:

GPS

WAAS SEARCH: AUTO

CORRECTIONS DATA SET: 02

DPGS STATION: AUTO

RATE: 000BPS

FREQ: 310.0kHz

STATION: GOOD* DATA:GOOD*

SIG. S: 55.2 dB* SNR: 22.0 dB*

STATION: Shows GOOD or NG.

DATA: Shows GOOD or NG.

SIG. S: Signal Strength. A figure be tween 0 and 99 is shown. The higher the figure the stronger the beacon signal.

SNR: Signal to Noise Ratio. A figure between 1 and 22 is shown. When your boat is in the service area of a beacon station, SNR should be 21 or 22. If the figure is below 18 the position will be inaccurate. If this happens, check for radar interference, poor ground and generator noise on own ship.

WAAS/DGPS menu

3. MODE is selected; press the [ENT] key.

GPS

WAAS

DGPS

AUTO

Position fix mode options

4.Choose appropriate mode referring to the description below and then press the [ENT] key.

GPS: Position fix by GPS

WAAS: Position fix by WAAS

DPGS: Position fix by DGPS (external beacon receiver required)

AUTO: Position fix in order of WAAS, DGPS and GPS

5.For WAAS or AUTO do as below. For GPS or DGPS go to step 6.

1)WAAS SEARCH is selected; press the [ENT] key.

AUTO

MANUAL

WAAS SEARCH options

3-16

Image 47
Contents Satellite Compass Safety Instructions Table of Contents Iii MAINTENANCE, TroubleshootingWord to the Owner of the SC-50 FeaturesForeword System configuration System ConfigurationName Type Code No Qty Remarks Equipment ListStandard supply Optional equipmentPrinciple of Operation This page intentionally left blank Antenna unit InstallationMounting Considerations Antenna and field of view Mast diameter Separation distance minimumHorizontal separation between antenna and masts Display unit, processor unit Example of antenna installed below superstructuresAntenna unit SC-303 Installing the Antenna UnitsMounting dimensions for antenna, orienting the antenna Cable from antenna No. marked on cable Waterproofing the antenna connectorHow to fasten the antenna cable Coating bolt, nut and washers with silicone sealantAntenna unit How to insert the cable coverAntenna unit SC-603 How to orient the antenna elementsAntenna unit SC-603 MountingFixing antenna unit to pedestal Orienting the antenna unit Orient the antenna unit as shown in the illustration belowWelding the antenna unit Antenna element Fastening the antenna cableProcessor unit orientation, deck mounting Installing the Processor UnitDeck, bulkhead mount Installation of processor unit on the underside of a desk Installation on the underside of a deskFlush mount F Installing the Display UnitDesktop, overhead mounting Flush mountFlush mount S Flush mount SFlush mount S kit Type OP20-17, Code No Processor unit, rear view WiringGeneral wiring diagram Sectional view of coaxial cable 3D2V How to install the optional antenna cable setHow to attach connector N-P-8DFB How to attach connector N-P-8DFBMain menu Initial SettingsInstallation setup menu Confirming satellite status choosing mounting methodSatellite tracking status display Heading setup menuChoosing heading source Processor unit, cover opened General wiringConnection of External Equipment Cable Sectional view, fabrication Fabrication of cablesDisplay unit OperationControls Processor unit Turning the Power On/OffPanel Illumination, Display Contrast Nav data display Choosing a DisplayDescription of displays Heading displayROT Rate-of-Turn display Steering displayCompass display Set and drift display, speed and distance run display Set and Drift display, Distance Run displayBuzzer options Dgps Alarm SetupAlarm menu Dgps alarm optionsSatellite status display Confirming Satellite StatusGPS Setup menu description GPS SetupDisplaying the GPS setup menu Heading Disable SV Disable satelliteOutput Data Baud rate options Data OUT1 menu, sentencesHeading talker options Tx interval optionsIEC, Nmea version options Log pulse options Log pulseGeodetic data System SetupSystem Setup menu Time format Using local timeUnits of measurement Demonstration mode Waas Search options WAAS/DGPS SetupPosition fix mode options WAAS/DGPS menuAUTO/MANUAL options Provider GEO Satellite LongitudeGEO satellite and coverage area Operation HDG Restoration options HDG Backup optionsOthers Menu Others menuTrip menu Trip MenuReset Distance prompt Resetting Distance RunThis page intentionally left blank Preventive Maintenance MAINTENANCE, TroubleshootingSymptom Cause Remedy TroubleshootingTroubleshooting Test start prompt DiagnosticsDiagnostic test1 Test menu optionsPush KEY Diagnostic test sequenceTEST2 display Diagnostic test2Alarm options Diagnostic test3Prompts for erasure of data Program NumberClearing Data Program version no. displayPrompt for turning off the power Replacement of BatteryBattery Location Type Code No Prompt for exchanging batteryMessage display Replacement of FuseError Messages Error Message Meaning RemedyData ERR Error messages con’t from previousAP-1 AppendixMenu Tree AP-2 SC-50 SpecificationsFuruno IN-1 IndexPacking List SC-501-J/E SC-303 工事材料表 Installation Materials フラッシュマウントキット 20AY-X-9403 SC-50/55/60 20AT-X-9410 Page Page Page