PAS4•S | 6 Diagnostics and troubleshooting |
|
|
6.3Replacing parts
Only replace the parts described. All other parts may only be replaced by technicians trained by the manufacturer.
Carry out a complete installation for replacing the entire axis as per see chapter 4 "Installation".
Adjust and check the linear axis as per chapter 5 "Commissioning" after replacing parts.
6.3.1Replacing a sensor
You can replace a sensor without changing the position of the sensor holder.
Unless otherwise specified, the standard tightening torques indicated on page 47 apply.
Prerequisites
Procedure
1
3 2
See chapter 7 "Accessories and spare parts" for suitable spare parts.
You need a set of Allen keys and a feeler gauge.
Loosen the M3 screw (2) at the slotted side of the sensor holder until the sensor to be replaced can be pulled out from below.
Mount the new sensor as described on page 50.
MNA1MLSDM00EN, V2.01, 07.2009
Portal axes with ball screw drive | 61 |