PAS4•S | 4 Installation |
|
|
Gearbox mounting only
1
MNA1MLSDM00EN, V2.01, 07.2009
A flange plate (1) is required if the gearbox does not have its own flange.
Mount the flange plate to the gearbox with the 4 screws. Verify that the flange plate has even contact.
Place the gearbox onto the motor adapted plate with even contact. Secure the gearbox to keep it from falling down.
If the gearbox has a parallel keyway, align the keyway and the slot of the clamping hub.
Fasten the gearbox with the 4 screws and washers.
Remove the screw plug in the hole at the side of the motor adapter plate.
Tighten the screw of the clamping hub through the hole with the tightening torque specified in Table 4.2.
Close the hole with the screw plug.
Please refer to the gearbox manual for mounting a motor to the gearbox.
Portal axes with ball screw drive | 53 |