Schneider Electric PAS4S manual Carriage type Type

PAS4•S 3 Technical Data

Carriage type			Type 1				Type 4
Cover strip			Yes	No			Yes	No
Number of ball screw supports			0, 1 or	0	1	2	0, 1 or	0	1	2
			2				2
Total length of portal axis 1)	LP	[mm]	466 +	369 +	399 +	429 +	646 +	549 +	579 +	609 +
			X	X	X	X	X	X	X	X
Total length of support axis	LS	[mm]	382 +	285 +	315 +	345 +	562 +	465 +	495 +	525 +
			X	X	X	X	X	X	X	X
Stroke	X	[mm]	See characteristics
Carriage length	LC	[mm]	323	226			503	406
Profile length of carriage	F	[mm]	190				370
Number of tapped holes for mounting 2)	n		10				22
Distance between tapped holes		[mm]	30 ±0.03				30 ±0.03
Limit switch position at drive end	E0	[mm]	98	50	65	80	98	50	65	80
Limit switch position opposite drive end	E1	[mm]	98	50	65	80	278	230	245	260
Stroke reserve to mechanical stop 3)	c	[mm]	10				10
Length of cover strip clamp	d	[mm]	11.5				11.5
Deflection of cover strip	D	[mm]	48.5	-			48.5	-
Minimum distance between 2 carriages		[mm]	90	35			90	35

1)In the case of axes with more than one carriage, you must add the carriage length (LC) and the distance between the carriages for each additional carriage. More than 1 carriage on request.

2)Prepared for locating rings (see Accessories)

3)The stroke reserve must be increased depending on the application factors load, acceleration and velocity. The displacement dis- tances must be taken into account in terms of the total length.

MNA1MLSDM00EN, V2.01, 07.2009

Portal axes with ball screw drive 29