Schneider Electric PAS4S manual Sensors and additional parts, Technical data

7 Accessories and spare parts PAS4•S

7.5Sensors and additional parts

7.5.1Sensors

Order data

		Description		Order no.
		With signal state indicator, 100	PNP, normally	XS508B1PBP01M8
		mm cable and 3-pin M8 circular	closed contact
	4	connector, suitable for all axes
			PNP, normally open	XS508B1PAP01M8
1	3	1 piece	contact
			NPN, normally	XS508B1NBP01M8
			closed contact
			NPN, normally	XS508B1NAP01M8
			open contact

Dimensional drawings

LED

L

		Total length	Thread length	Cable length
		A	B	L
	M8	[mm]	[mm]	[mm]
B		33	25	100

A

See chapter 4.3.1 "Connecting the sensors" for the connection assignment.

Technical data

Design		Cylindrical thread M8 x 1
Approvals		CE
Electrical connection (PUR cable with M8 connector)	[m]	0.10
Nominal switching distance Sn(in the case of steel)	[mm]	1.5
Hysteresis		1 to 15% of the real switching distance
Degree of protection as per IEC 60529		IP67
Temperature (storage)	[°C]	-40 ... +85
Temperature (operation)	[°C]	-25 ... +70
Housing material		Nickel-plated brass
Cable material		PUR, 3 x 0.12 mm2, length 10 cm
Function indicator output		Yellow LED
Function indicator supply voltage		No
Supply voltage (PELV)	[Vdc]	12 ... 24 with reverse polarity protection	07.2009
Supply voltage (including residual ripple)	[Vdc]	10 ... 36
Switching current (overload and short-circuit protection)	[mA]	< 200
			V2.01,
Voltage drop, output conducting	[V]	< 2
No-load current	[mA]	< 10	MNA1MLSDM00EN,
Maximum switching frequency	[Hz]	5000
Switch-on time	[ms]	< 0.1
Switch-off time	[ms]	< 0.1

72 Portal axes with ball screw drive