4 Installation | PAS4•S |
|
|
4.2.2Mounting the linear axis
Only mount the linear axis using the T slots at the axis body. To do so, use clamping claws (lateral fastening) or slot nuts (bottom or lateral fas- tening).
A selection of suitable clamping claws and slot nuts can be found in chapter 7 "Accessories and spare parts".
Note the following:
•When using motors with a cross section greater than the cross sec- tion than the axis body, the axis must be supported or the mounting surface must be cut out as required.
•The end blocks protrude beyond the axis body at the ends. The end blocks must not be the only parts supported by the mounting sur- face.
•If the lateral slots are used for mounting, the sensor cable cannot be completely routed in the slots.
A | C | |
B | ||
| ||
1 | 2 |
Figure 4.1 Fastening by means of clamping claws (1) and slot nuts from the bottom (2)
Tapped hole distance | PAS42 | PAS43 | PAS44 | |
|
|
|
|
|
A | [mm] | 74 | 96 | 130 |
|
|
|
|
|
B | [mm] | 88 | 112 | 150 |
|
|
|
|
|
C | [mm] | 40 | 50 | 70 |
|
|
|
|
|
Maximum distance 1) | PAS42 | PAS43 | PAS44 | |
Clamping claws | [mm] | 600 | 800 | 1000 |
|
|
|
|
|
Slot nuts | [mm] | 600 | 800 | 1000 |
|
|
|
|
|
1) Recommended values per side at medium loads
The greater the load or the demands on the running accuracy, the shorter the distance between the slot nuts or the clamping claws must be.
MNA1MLSDM00EN, V2.01, 07.2009
48 | Portal axes with ball screw drive |