Pioneer DJM-700-S, DJM-700-K operating instructions Connections, Connection Panel

CONNECTIONS

CONNECTIONS

CONNECTION PANEL

1 2 3 4 5 6 7 8 9

		CH-4	CH-3	CH-2	CH-1
BOOTH	REC	PHONO LINE	PHONO LINE	PHONO CD	LINE	CD

POWER	L	L	L	L	L
	OFF				MIC 2
	ON			CONTROL	CONTROL
	1 GND 2 HOT

R	R			R	R		R
3 COLD R MASTER1 L					SIGNAL GND
MASTER2		MASTER			SEND	RETURN	DIGITAL OUT	MIDI OUT
R	L			R	L(MONO) R	L(MONO)
			ATT.				fs(Hz)
		-6dB	-3dB 0dB				48k 96k

English

18 17 16

1POWER switch

2BOOTH monitor output connectors RCA-type booth monitor output jack.

The sound level from these connectors is controlled independently by the BOOTH MONITOR LEVEL dial, regardless of the position of the MASTER LEVEL dial.

3Recording output connectors (REC)

RCA type output connectors for recording.

4 PHONO input connectors

RCA type phono level (MM cartridge) input connectors. Do not use for inputting line level signals.

5 LINE input connectors

RCA type line level input connectors.

Use to connect a cassette deck or other line level output component.

6 CD input connectors

RCA type line level input connectors.

Use to connect a DJ CD player or other line level output component.

7 CONTROL connectors

Ø3.5 mm mini-connector. Use to connect to the control connector of a Pioneer DJ CD player.

When the connectors are connected, the DJM-700-S/DJM-700-K’s fader can be used to perform start/stop on the DJ CD player.

8 Two microphone input jacks (MIC 2)

Connect microphones equipped with phone-type plugs.

9Signal grounding terminals (SIGNAL GND) Reduces noise when connecting an analog turntable.

10MIDI OUT connector

DIN type output connector.

Use to connect to other MIDI component (see P. 21).

15 14 13 12 11 10

11 DIGITAL OUT connector

RCA type digital coaxial output connector.

Master audio digital output.

12 Sampling frequency selector switch (fs 48 k/96 k)

Use to set the sampling frequency of the digital output to 96 kHz/ 24-bit format or 48 kHz/24-bit format.

•Turn power off before changing this switch position.

13 RETURN connectors

Ø6.3 mm phone-type input connectors.

Use to connect to the output connectors of external effectors or similar components.

When the L channel only is connected, the L channel input is simultaneously input to the R channel.

14 SEND output connectors

Ø6.3 mm phone-type output connectors.

Use to connect to the input connectors of external effectors or other similar components. When the L channel only is connected, a L+R monaural signal is output.

15 Master output attenuator switch (MASTER ATT)

Use to attenuate the level of the master 1 and master 2 outputs. Attenuation can be set to 0 dB, –3 dB, or –6 dB.

16 MASTER 2 output connectors RCA type unbalanced output.

17 MASTER 1 output connectors XLR type (male) balanced output.

•When using a cord with RCA-type plug, users are recommended to connect the plug directly to the MASTER 2 connectors without using an XLR/RCA converter plug.

18 Power cord

Connect to ordinary AC outlet.

5

En