Peavey TransChorus 210 manual TRANSCHORUSª 210 Specifications

Page 29

TRANSCHORUSª 210 SPECIFICATIONS

(ALL MEASUREMENTS @ 120 V AC, 60HZ)

POWER AMPLIFIER SECTION

RATED OUTPUT POWER:

Power specs measured with T. Dynamics @ 100% (5% THD, 1 kHz, 120 V AC)

50 W RMS per channel, into 8 ohms

FREQUENCY RESPONSE:

Stereo mode into 8 ohm, power amp inputs

-3 dB, +2 dB, 70 Hz to 20 kHz, @ 45 W RMS into 8 ohms

HUM AND NOISE:

Unweighted, 20 Hz to 22 kHz

Greater than 90 dB, both channels

POWER CONSUMPTION:

Domestic Model: 120 V AC, 60 Hz, 2.5A, 300 W

Export Model: 220 to 240 V AC, 50/60 Hz, 300 W

PREAMP SECTION

(The following specs are measured @ 1 kHz with the controls preset as follows:)

Push Bright, off (out)

Channel Select Clean (out)

Low and High @ 10

Mid @ 0

Crunch Pre and Post Gain @ 10

Gain and Thrash, off (out)

Lead Pre and Post Gain @ 10

Gain and Mid Boost, off (out)

Normal levels are with normal volume @ 5

Minimum levels are with clean volume @ 10

PREAMP HIGH GAIN INPUT:

Impedance: High-Z, 1 M ohm

Nominal Input Level: -12 dBV, 250 mV RMS

Minimum Input Level: -22 dBV, 79 mV RMS

Maximum Input level: 0 dBV, 1 V RMS

PREAMP LOW GAIN INPUT:

Impedance: High-Z, 44 k ohms

Nominal Input Level: -6 dBV, 500 mV RMS

Minimum Input Level: -16 dBV, 158 mV RMS

Maximum Input level: 6 dBV, 2 V RMS

PREAMP OUTPUT:

Load Impedance: 300 ohm or greater

Nominal Output Level: 0 dBV, 1 V RMS

POWER AMP INPUT:

Impedance: High-Z, 30 k ohms

Designed Input Level: 0 dBV, 1 V RMS (Switching jack provides preamp output to power amp input connection when not used.)

SYSTEM HUM AND NOISE @ NOMINAL INPUT LEVEL

UNWEIGHTED, 20 Hz to 22 kHz

Greater than 75 dB, below rated power

EQUALIZATION:

Special low, mid and high passive type EQ Push Bright: +4 dBV @ 2 kHz, (Clean channel) Push Thrash: -6 dBV notch 1 kHz, (Crunch channel) Push Mid boost: +3 dBV band pass 1 kHz, (Lead channel) Push Gain: Increase gain both Lead and Crunch channels

EXTERNAL FOOT SWITCH FUNCTIONS:

Lead/Crunch: Selects lead or crunch channel.

Bypass/Clean: Lead and Crunch channel defeat (channel switch ÒINÓ)

Select/Chorus: Defeat Chorus

DIMENSIONS AND WEIGHT (H x W x D):

18.5" x 23.375" x 11.375" 47cm x 10.60cm x 29cm

29

Image 29
Contents A N S C H O R U S 2 1 Page Quick Start Ñ I just want to play TransChorusªFront Panel Gain Switch Thrash SwitchMid Boost Switch Crunch Channel PregainRear Panel AC Line CORDÑ120 V Products only Recommended Settings ALL Measurements @ 120 V AC, 60HZ Power Amplifier Section TRANSCHORUSª 210 SpecificationsClean TransChorusª 210 Block DiagramImportant Safety Instructions Inicio r‡pido Ñ ÁS-lo deseo ejecutar ESPA„OLPanel Frontal Canal de efectos estridentes Preganancia Ecualizaci-n de bajos, medios y altosConmutador ÒthrashÓ filtro parcial Conmutador de gananciaPanel Posterior Interruptor remoto Entrada del amplificador de potenciaSalida del preamplificador SECCIîN DEL Preamplificador Especificaciones DEL Amplificador TRANSCHORUSªInstrucciones DE Seguridad Importantes DŽmarrage rapide FRAN‚AISEntrŽe High Gain Canal Clean VolumeEntrŽe LOW Gain SŽlecteur Bright12. SŽlecteur Mid Boost Canal Lead Pregain13. SŽlecteur de Gain 16. RŽverbeFace ARRIéRE TRANSCHORUSª 210 Specifications Conservez CES Instructions Quick Start Ñ Ich will spielen DeutschDIE Front DIE R†CKSEITE AC Line CORDÑNur bei 120 Volt-GerŠten TRANSCHORUSª 210 Specifications Wichtige Sicherheitsrichtlinien Peavey Electronics Corporation Limited Warranty Features and specifications subject to change without notice