Check for GAS Leaks

GAS INSTRUCTIONS

Remove Side Burner Cabinet Back Panel and

Side Burner Cabinet Water Deflector

Tools required: Phillips screwdriver..

A)Facing the back of the unit, remove screws that secure back panel of side burner cabinet with a Phillips screwdriver (1)..

B)Remove back panel and set aside (2)..

C)Facing the front of the unit, open side burner cabinet door and remove screw securing side burner cabinet water deflector (3)..

D)Facing the back of the unit, push water deflector forward to allow rear edge to drop down.. Pivot down on an angle and remove from side burner cabinet (4).. ◆

m DANGER

Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. Sparks or open flames will result in a fire or explosion, which can cause serious bodily injury or death and damage to property.

Note: All factory-made connections have been thoroughly checked for gas leaks.The burners have been flame-tested.As a safety precaution, however, you should recheck all fittings for leaks before using your Weber® gas barbecue. Shipping and handling may loosen or damage a gas fitting.

m WARNING: The gas connections of your gas grill have been factory tested. We do however recommend that you leak check all gas connections before operating your gas grill.

mWARNING: Perform these leak checks even if your barbecue was dealer or store assembled.

If your grill has a side burner, make sure the side burner is turned off..

Turn on gas supply at source..

mWARNING: Do not ignite burners when leak checking.

You will need: A soap and water solution and a rag or brush to apply it..

A)Mix soap and water..

B)Turn on gas supply (1)..

C)Check for leaks by wetting the fitting with the soap and water solution and watching for bubbles.. If bubbles form, or if a bubble grows, there is a leak..

If there is a leak, turn off the gas and tighten the fitting. Turn the gas back on and recheck with the soap and water solution. If leak does not stop, do not use the barbecue. Contact the Customer Service representative in your area using the contact information on our web site. Log onto www.weber.com®.

D)When leak checking is complete, turn gas supply off at the source and rinse connections with water..

Note: Since some leak test solutions, including soap and water, may be slightly corrosive, all connections should be rinsed with water after checking for leaks.

mWARNING: You should check for gas leaks every time you disconnect and reconnect a gas fitting.