Invacare M71 service manual 104

Page 104

SECTION 12—DISASSEMBLING/ASSEMBLING THE M71

CAUTION

When flipping back the seat, be sure to maintain a grip on the seat so it does not flip over the back of the base frame - otherwise damage to the wheelchair may result.

2.Van Seat ONLY: Pull the recline lever up and bring the seat back all the way forward.

3.Remove the seat. Refer to Removing/Installing the Seat Assembly on page 30.

4.While standing at the REAR of the wheelchair base, disconnect the LEFT motor connector from the controller and insert the motor connector into the opening in the side shroud behind the left motor release lever.

5.Disconnect the right motor connector from the controller and insert the motor connector into the opening in the side shroud behind the right motor release lever.

Removing the Batteries

6.Disconnect the rear battery from the front battery (GREY connector).

7.Disconnect the front battery from the controller (BLACK connector on the standard M71).

8.Remove the rear battery and place on the ground away from the wheelchair base.

9.Slide the front battery rearward then remove and place on the ground away from the wheelchair base.

Removing the Left Side Frame Assembly

10.Using your left hand, grip the left side frame at the large cutout in the side shroud.

11.Using your right hand, lift up on the frame release lever at the front of the battery section on the left side (Left Side Frame Label #1).

12.While the frame release lever is activated, separate the upper front clevis pin (Left Side Frame Label #1) and upper rear clevis pin (Left Side Frame Label #2) away from the battery section while simultaneously lifting the frame release lever and battery section.

13.Continue lifting the battery section with the right hand until the battery section lifts completely away from the lower clevis of the left side frame (Left Side Frame Label #3).

14.Slide the left side frame away from the battery section and lay down on its side or leave in an upright position by turning both the front and rear caster inward.

15.Repeat STEPS 9-13 to remove the right side frame assembly.

16.Store the seat assembly, left and right side frames, battery section and batteries safely and securely as required in your vehicle. Side frames should be stored on their side to prevent them from tipping over.

Pronto® M71™

104

Part No 1118377

Image 104
Contents Pronto M71 Document Part Number Reference DocumentsReference Documents Table of Contents Seat Assembly Removing/Installing the Adjustable Height TubesArms WheelsMotors Front RIGGINGS/FOOTBOARDSHROUDS/FRAME Limited Warranty BATTERIES/CHARGERController and Joystick DISASSEMBLING/ASSEMBLING the M71Seat Positioning Strap Signal Word MeaningSpecial Notes Trro and Trbkts Warnings Wiring Label on M71 Standard with Battery Covers Label LocationsOne of these battery wiring Labels is in this location M71 with PTO+ Labels Inch VAN Asba Typical Product ParametersTypical Product Parameters Operation Information Repair or Service InformationGeneral Guidelines Tire Pressure ElectricalBatteries Grounding InstructionsEMI Information EMI InformationEMI Information Inspect/Adjust Safety INSPECTION/ TroubleshootingSafety Inspection Checklists Display Description Definition TroubleshootingTroubleshooting Electrical SUB Code Diagnostics CodePossible Solution E05 Symptom SolutionsJS REV TOO Large Troubleshooting Common Troubleshooting Motor/Gearbox/BrakeSymptom Probable Cause Solutions WheelsTion. Replace motor or gearbox if contamination Troubleshooting Battery Troubleshooting Battery ChargerChecking Battery Charge Level DON’TField Load Test Motor Testing Battery QualitySeat Assembly Removing/Installing the Seat AssemblyInstalling Seat Removing SeatAdjusting the Seat Height Removing/Installing the Seat AssemblyVAN Seat with Hemi Front Rigging or Footboard Wheelchair Equipped with Available Mounting Holes forVAN Seat with NON-HEMI Front Rigging Removing/Installing the Adjustable Height Tubes Asba Seat with Footboard Or Front Riggings NON-HEMI or HemiRemoving/Installing the Adjustable Height Tubes Adjustable Asba Seat Service Procedures Removing/Installing the Seat PanAdjusting the Seat Width Seat WidthAdjusting the Seat Depth Frame Size Seat Depth RangeSeat Depth DISTANCE* in Inches Removing/Installing Side Rails Adjusting the Seat DepthRemoving/Installing Side Rails Replacing the Seat Frame Replacing the Seat FrameRemoving/Installing the Back Canes Removing/Installing the Back Canes Replacing Seat Positioning StrapAdjusting the Back Angle 11 Adjusting the Back AngleAsba Seat Service Procedures 12 Removing/Installing the Seat PanChanging the Seat Width/Depth Replacing the Seat Frame 13 Replacing the Seat FrameReplacing the Seat Positioning Strap Back UpholsterySeat Assembly Seat Assembly 15 Removing/Installing the Back Upholstery Back Height16 Adjusting the Back Angle Angle Back Cane Mounting Hole Back Angle Plate HoleVan Seat Service Procedures Adjusting the Seat Position on Van Seat Frame18 Adjusting the Seat Position on Van Seat Frame Adjusting the Van Seat Back Depth Back Depth Seat SizeArm Service Procedures for Van Seat Removing/Installing Van Seat ArmAdjusting Van Seat Arm Width ArmsAdjusting Van Seat Arm Angle Adjusting Van Seat Arm HeightArmrest Pad Armrest Insert Mounting Screw Arm Post Washers Locknut Adjusting the Flip Back Armrest Arm Service Procedures for Asba or Adjustable Asba SeatRemoving/Installing Flip Back Armrest Adjusting the Flip Back Armrest Wheels Replacing the Front/Rear CastersAdjusting Caster Assembly Adjusting Caster AssemblyRemoving/Installing the Front/Rear Caster Assemblies Removing/Installing the Front Headtube AssemblyInstalling RemovingRemoving the Drive Wheel Removing/Installing the Drive WheelInstalling the Drive Wheel Removing/Installing the Drive Wheel Inner Rim Installing/Removing Front Riggings Front RIGGINGS/ FootboardModel PH904A and PHAL4A Front Riggings Adjusting Footrest HeightModel PHWH93 Front Riggings Adjusting/Replacing Telescoping Front Rigging Supports Replacing Heel LoopsRaising/Lowering Elevating Front Riggings Van SeatStandard Position Inch OUT Inches OUT Adjustable Asba Seat Asba SeatRemoving/Installing the Footboard Assembly Depth Adjustment Angle/Depth/Height Adjustment of the Footboard AssemblyAngle Adjustment Height Adjustment 11 Depth Adjustment/Height AdjustmentRemoving/Installing the Shrouds SHROUDS/FRAMERemoving/Installing the Shrouds Disassembling/Reassembling the Side Frame Assembly Removing/Installing the Pivot TubeDisassembling/Reassembling the Side Frame Assembly Removing/Installing the SureStep Springs Removing/Installing the SureStep Springs Removing/Installing the Motor MotorsRemoving/Installing the Motor Release Lever Removing/Installing the Motor Release LeverReplacing Internal Motor Brushes Replacing Internal Motor Brushes Inspecting/Replacing External Motor Brushes Electro-Mechanical Parking Brake Testing Electro-Mechanical Parking Brake TestingBATTERIES/CHARGER Using the Proper Batteries Using the Proper BatteriesRemoving/Installing Batteries From/Into Battery Tray Tool Quantity CommentsInstalling Batteries Removing BatteriesRemoving/Installing Batteries From/Into Battery Tray Connecting/Disconnecting Battery Cables Connecting Battery Cables20 x 7/8-Inch Disconnecting Battery Cables Removed for clarityReplacing the On-Board Battery Charger Fuse Replacing the On-Board Battery Charger Replacing the On-Board Battery Charger FuseReplacing the On-Board Battery Charger Disconnecting/Connecting the Joystick DisconnectingConnecting Controller and JoystickRemoving/Installing the Joystick Van Seat ModelsAsba and Adjustable Asba Models Removing/Installing the Joystick Van Seat ModelsReplacing the Mkiv RII Controller Replacing the Mkiv RII Controller Replacing the MK5-NX or MK660 ACC Controller Replacing the MK5-NX or MK660 ACC ControllerDisassembling the Wheelchair DISASSEMBLING/ Assembling the M71Disassembling/Assembling the Wheelchair 104 Disassembling the Wheelchair Assembling the Wheelchair Assembling the Wheelchair Final Assembly Transport Ready Package Specifications Model Wheelchair Weight LimitAbout Transport Ready Packages Compliance InformationSecuring the Wheelchair to the Vehicle Positioning the Wheelchair in the VehicleSecurement Points Securing the WheelchairSecuring the Occupant Wheelchair-Anchored BeltsRating Description Vehicle-Anchored BeltsSeating System Positioning Belts Positioning BeltsLimited Warranty USA
Related manuals
Manual 28 pages 55.84 Kb