Invacare M71 service manual Adjusting the Seat Height, Removing/Installing the Seat Assembly

SECTION 4—SEAT ASSEMBLY

Joystick

Connector

DETAIL “A”

Seat

Latch Bar is located under the front of the seat

DETAIL “B”

Seat

Seat

Brackets

Rear Pivot

Brackets

Seat

Clevis

Pins

FIGURE 4.1 Removing/Installing the Seat Assembly

Adjusting the Seat Height

WARNING

For wheelchairs with POWER TILT ONLY, refer to ADJUSTING SEAT HEIGHT in SECTION 4 of the Power Tilt Only for Pronto M71 and M91 owner’s manual, Part Number 1118362.

PTO PLUS ONLY - DO NOT adjust the seat height. Adjusting the seat height from the factory setting will make the wheelchair unstable and injury or damage may occur. The M71 wheelchair seat should only be mounted in mounting hole B (FIGURE 4.2).

For users over 250 lbs: The seat MUST be mounted in the furthest rearward position and the front seat posts MUST be in the 1-inch raised position or lower mounting holes A or B. Refer to Table: Available Mounting Holes on page 32 for available mounting positions.

DO NOT adjust the rear seat posts higher than the front seat posts.

NOTE: For this procedure, refer to FIGURE 4.2 on page 32.

NOTE: The seat can be adjusted to five height positions in 1/2-inch increments.

1.Remove the seat assembly. Refer to Removing/Installing the Seat Assembly on page 30.

Part No 1118377 31 Pronto® M71™