Invacare M71 service manual Adjusting Footrest Height, Model PHWH93 Front Riggings

SECTION 7—FRONT RIGGINGS/FOOTBOARD

Adjusting Footrest Height

Model PHWH93 Front Riggings

NOTE: For this procedure, refer to FIGURE 7.2.

1.Remove any accessory from the front rigging(s).

2.Remove the front rigging from the wheelchair. Refer to Installing/Removing Front Riggings on page 66.

NOTE: Lay front rigging on a flat surface to simplify procedure.

3.Remove the hex bolt, coved washers and locknut that secure the lower footrest to the footrest support.

4.Reposition the lower footrest to the desired height.

5.Reinstall hex bolt, coved washers and locknut that secure lower footrest to footrest support. Tighten securely.

6.Repeat STEPS 1-5 for the opposite side of the wheelchair footrest, if necessary.

7.Reinstall the footrest(s) onto the wheelchair. Refer to Installing/ Removing Front Riggings on page 66.

Locknu	Footrest Support
	Coved Washer
Coved	Hex Bolt
Washer
	Lower
	Footrest

FIGURE 7.2 Model PHWH93 Front

Riggings

Model PH904A and PHAL4A Front Riggings

NOTE: For this procedure, refer to FIGURE 7.3.

1.Loosen, but DO NOT remove the lug bolt and locknut that secure the lower footrest to the footrest support.

2.Reposition the lower footrest to the desired height.

3.Securely tighten the lug bolt and locknut that secure the lower footrest to the footrest support.

4.Repeat STEPS 1-3 for the opposite side of the wheelchair footrest, if necessary.

Footrest

Support	Locknut
	Lower Footrest

Lug Bolt

NOTE: PH904A style front rigging shown. PHAL4A front rigging adjust the same way.

FIGURE 7.3 Model PH904A and PHAL4A

Front Riggings

Part No 1118377 67 Pronto® M71™