Invacare M71 service manual Removing/Installing the Back Canes

SECTION 4—SEAT ASSEMBLY

Removing/Installing the Back Canes

NOTE: For this procedure, refer to FIGURE 4.9 on page 42.

NOTE: Existing hardware will be reused.

NOTE: Take note of position and orientation of mounting hardware for reinstallation.

Removing

1. Remove armrest from the wheelchair. Refer to the wheelchair owner’s manual. NOTE: Note the back angle before disassembly for proper reinstallation.

2.For proper installation, note the mounting position of the upper hex screw securing the cane bracket to the back cane.

3.Remove the upper hex screw, washer and locknut securing the cane bracket to the back cane.

4.Remove the lower hex screw, washer and locknut securing the cane bracket to the back cane.

5.Remove the back cane from the wheelchair.

6.Repeat STEPS 1 - 6 for the opposite back cane.

Installing

NOTE: If replacing back canes, discard existing back canes and perform this procedure using new back canes.

1.Install the lower hex screw, washer and locknut through the slot in the cane bracket to secure the cane bracket to the back cane.

NOTE: The cane bracket should be positioned as shown in FIGURE 4.9.

2.Install the upper hex screw, washer and locknut through one of the following:

•Using the Same Back Angle - the mounting hole noted in STEP 3 of Removing on page 41.

•Changing the Back Angle - the mounting hole determined in Adjusting the Back Angle on page 43.

3.Torque both locknuts to 13 ft-lbs.

4.Repeat STEPS 1 - 3 for the opposite back cane.

5.Reinstall the flip back armrest onto the wheelchair. Refer to the wheelchair owner’s manual.

Part No 1118377 41 Pronto® M71™