Invacare M71 service manual 20 x 7/8-Inch

SECTION 10—BATTERIES/CHARGER

6.Secure each terminal cap in place with a tie-wrap (use tie-wraps 11-1/2-inches long) (DETAIL “B” of FIGURE 10.4 or FIGURE 10.5).

NOTE: It will be necessary to trim excess tie-wrap in order to install the battery box top(s).

7.If necessary, install the battery box top(s) using the nylon webbing straps and snug the adjuster against the box top (Detail “C” of FIGURE 10.4).

8.Position the battery(ies) into the wheelchair. Refer to Installing Batteries on page 89.

NOTE: New Battery(ies) MUST be fully charged before using, otherwise the life of the battery(ies) will be reduced.

9.If necessary, charge the battery(ies). Refer to Charging Batteries in owner’s manual shipped with wheelchair.

DETAIL “A”

1/4-20 x 7/8-Inch	NEGATIVE (-) Battery
Hex Flange Screw	Terminal/Post
U1 Battery	1/4-20 Hex
	Flange Locknut

Positive (+) Battery

Terminal/Post

Connect battery

cable(s) ring

terminal(s) to this

side of battery

terminal(s)/post(s)

	DETAIL “B”
POSITIVE (+) Battery		NEGATIVE (-) Battery
		Terminal/Post
Terminal/Post
		Tie-Wrap
Tie-Wrap
U1		ORANGE
Battery
		Battery
		Terminal Cap
	DETAIL “C”
Nylon
Webbing Strap

FIGURE 10.4 Connecting/Disconnecting Battery Cables - Wheelchairs Manufactured Before

7/14/03

Pronto® M71™ 92 Part No 1118377