SECTION 7—FRONT RIGGINGS/FOOTBOARD
WARNING
Make sure the detent balls are engaged with the outer edge of the tube - otherwise, injury and/or damage may result.
2.Adjust footboard to one of three mounting positions.
3.Install the quick release pin. Make sure the detent balls are engaged with the outer edge of the tube.
Height Adjustment
NOTE: For this procedure, refer to FIGURE 7.11.
1.Remove the quick release pin that secures the footboard assembly to the wheelchair frame.
2.Remove mounting screw, washer, bushing, locknut and two nylon washers that secure the footboard to the footboard support.
3.Align footboard mounting holes with one of three height adjustment mounting holes.
4.Using the mounting screw, washer, bushing, locknut and two nylon washers, secure the footboard to the footboard support.
5.Insert footboard support, with footboard attached, into the wheelchair frame and align wheelchair frame mounting holes with the desired depth adjustment mounting holes in the footboard assembly.
WARNING
Make sure the detent balls of the
Keep detent balls clean.
6.Using the quick release pin, secure the footboard assembly to the wheelchair frame. Make sure the detent balls are engaged with the outer edge of the tube.
Wheelchair Frame | Depth Adjustment Holes |
| Height Adjustment Holes |
| Nylon Washers |
| Washer |
Mounting Hole | Mounting Screws |
| |
Quick Release Pin |
|
Footboard Support |
|
Bushing | Footboard |
Locknut |
Bottom view
Quick Release
Pin
Detent Balls
Outer Edge of
Tube
FIGURE 7.11 Depth Adjustment/Height Adjustment
Part No 1118377 | 73 | Pronto® M71™ |