Invacare M71 service manual Batteries/Charger

Page 86

SECTION 10—BATTERIES/CHARGER

SECTION 10—BATTERIES/CHARGER

Warnings For Handling and Replacing Batteries

WARNING

After ANY adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result.

Make sure power to the wheelchair is Off before performing this section.

The use of rubber gloves is recommended when working with batteries.

Invacare strongly recommends that battery installation and battery replacement ALWAYS be done by a qualified technician.

U1 batteries weight 18 pounds each. Use proper lifting techniques (lift with your legs) to avoid injury.

Use U1 batteries only. Failure to use the correct battery size and/or voltage may cause damage to your wheelchair and give you unsatisfactory performance.

ALWAYS use a battery lifting strap when lifting a battery. It is the most convenient method and assures that the battery acid will not spill. It also helps to prolong the life of the battery.

DO NOT tip the batteries. Keep the batteries in an upright position.

NEVER allow any of your tools and/or battery cables to contact BOTH battery posts at the same time. An electrical short may occur and serious personal injury or damage may occur.

The POSITIVE (+) RED battery cable must connect to the POSITIVE (+) battery terminal, otherwise serious damage will occur to the electrical system.

NOTE: If there is battery acid in the bottom of the battery tray or on the sides of the batteries, apply baking soda to these areas to neutralize the battery acid. Before reinstalling the existing or new batteries, clean the baking soda from the battery tray or batteries being sure to avoid contact with skin and eyes. Determine source of contamination. Never install/reinstall a battery with a cracked or otherwise damaged case.

Pronto® M71™

86

Part No 1118377

Image 86
Contents Pronto M71 Document Part Number Reference DocumentsReference Documents Table of Contents Seat Assembly Removing/Installing the Adjustable Height TubesArms WheelsMotors Front RIGGINGS/FOOTBOARDSHROUDS/FRAME Controller and Joystick Limited WarrantyBATTERIES/CHARGER DISASSEMBLING/ASSEMBLING the M71Seat Positioning Strap Signal Word MeaningSpecial Notes Trro and Trbkts Warnings Wiring Label on M71 Standard with Battery Covers Label LocationsOne of these battery wiring Labels is in this location M71 with PTO+ Labels Inch VAN Asba Typical Product ParametersTypical Product Parameters Operation Information Repair or Service InformationGeneral Guidelines Batteries Tire PressureElectrical Grounding InstructionsEMI Information EMI InformationEMI Information Inspect/Adjust Safety INSPECTION/ TroubleshootingSafety Inspection Checklists Display Description Definition TroubleshootingTroubleshooting Electrical SUB Code Diagnostics CodePossible Solution E05 Symptom SolutionsJS REV TOO Large Symptom Probable Cause Solutions Troubleshooting CommonTroubleshooting Motor/Gearbox/Brake WheelsTion. Replace motor or gearbox if contamination Troubleshooting Battery Troubleshooting Battery ChargerChecking Battery Charge Level DON’TField Load Test Motor Testing Battery QualityInstalling Seat Seat AssemblyRemoving/Installing the Seat Assembly Removing SeatAdjusting the Seat Height Removing/Installing the Seat AssemblyVAN Seat with Hemi Front Rigging or Footboard Wheelchair Equipped with Available Mounting Holes forVAN Seat with NON-HEMI Front Rigging Removing/Installing the Adjustable Height Tubes Asba Seat with Footboard Or Front Riggings NON-HEMI or HemiRemoving/Installing the Adjustable Height Tubes Adjusting the Seat Width Adjustable Asba Seat Service ProceduresRemoving/Installing the Seat Pan Seat WidthAdjusting the Seat Depth Frame Size Seat Depth RangeSeat Depth DISTANCE* in Inches Removing/Installing Side Rails Adjusting the Seat DepthRemoving/Installing Side Rails Replacing the Seat Frame Replacing the Seat FrameRemoving/Installing the Back Canes Removing/Installing the Back Canes Replacing Seat Positioning StrapAdjusting the Back Angle 11 Adjusting the Back AngleAsba Seat Service Procedures 12 Removing/Installing the Seat PanChanging the Seat Width/Depth Replacing the Seat Frame 13 Replacing the Seat FrameReplacing the Seat Positioning Strap Back UpholsterySeat Assembly Seat Assembly 15 Removing/Installing the Back Upholstery Back Height16 Adjusting the Back Angle Angle Back Cane Mounting Hole Back Angle Plate HoleVan Seat Service Procedures Adjusting the Seat Position on Van Seat Frame18 Adjusting the Seat Position on Van Seat Frame Adjusting the Van Seat Back Depth Back Depth Seat SizeAdjusting Van Seat Arm Width Arm Service Procedures for Van SeatRemoving/Installing Van Seat Arm ArmsAdjusting Van Seat Arm Angle Adjusting Van Seat Arm HeightArmrest Pad Armrest Insert Mounting Screw Arm Post Washers Locknut Adjusting the Flip Back Armrest Arm Service Procedures for Asba or Adjustable Asba SeatRemoving/Installing Flip Back Armrest Adjusting the Flip Back Armrest Wheels Replacing the Front/Rear CastersAdjusting Caster Assembly Adjusting Caster AssemblyInstalling Removing/Installing the Front/Rear Caster AssembliesRemoving/Installing the Front Headtube Assembly RemovingRemoving the Drive Wheel Removing/Installing the Drive WheelInstalling the Drive Wheel Removing/Installing the Drive Wheel Inner Rim Installing/Removing Front Riggings Front RIGGINGS/ FootboardModel PH904A and PHAL4A Front Riggings Adjusting Footrest HeightModel PHWH93 Front Riggings Raising/Lowering Elevating Front Riggings Adjusting/Replacing Telescoping Front Rigging SupportsReplacing Heel Loops Van SeatStandard Position Inch OUT Inches OUT Adjustable Asba Seat Asba SeatRemoving/Installing the Footboard Assembly Depth Adjustment Angle/Depth/Height Adjustment of the Footboard AssemblyAngle Adjustment Height Adjustment 11 Depth Adjustment/Height AdjustmentRemoving/Installing the Shrouds SHROUDS/FRAMERemoving/Installing the Shrouds Disassembling/Reassembling the Side Frame Assembly Removing/Installing the Pivot TubeDisassembling/Reassembling the Side Frame Assembly Removing/Installing the SureStep Springs Removing/Installing the SureStep Springs Removing/Installing the Motor MotorsRemoving/Installing the Motor Release Lever Removing/Installing the Motor Release LeverReplacing Internal Motor Brushes Replacing Internal Motor Brushes Inspecting/Replacing External Motor Brushes Electro-Mechanical Parking Brake Testing Electro-Mechanical Parking Brake TestingBATTERIES/CHARGER Using the Proper Batteries Using the Proper BatteriesRemoving/Installing Batteries From/Into Battery Tray Tool Quantity CommentsInstalling Batteries Removing BatteriesRemoving/Installing Batteries From/Into Battery Tray Connecting/Disconnecting Battery Cables Connecting Battery Cables20 x 7/8-Inch Disconnecting Battery Cables Removed for clarityReplacing the On-Board Battery Charger Fuse Replacing the On-Board Battery Charger Replacing the On-Board Battery Charger FuseReplacing the On-Board Battery Charger Connecting Disconnecting/Connecting the JoystickDisconnecting Controller and JoystickRemoving/Installing the Joystick Van Seat ModelsAsba and Adjustable Asba Models Removing/Installing the Joystick Van Seat ModelsReplacing the Mkiv RII Controller Replacing the Mkiv RII Controller Replacing the MK5-NX or MK660 ACC Controller Replacing the MK5-NX or MK660 ACC ControllerDisassembling the Wheelchair DISASSEMBLING/ Assembling the M71Disassembling/Assembling the Wheelchair 104 Disassembling the Wheelchair Assembling the Wheelchair Assembling the Wheelchair Final Assembly Transport Ready Package About Transport Ready Packages SpecificationsModel Wheelchair Weight Limit Compliance InformationSecuring the Wheelchair to the Vehicle Positioning the Wheelchair in the VehicleSecurement Points Securing the WheelchairSecuring the Occupant Wheelchair-Anchored BeltsRating Description Vehicle-Anchored BeltsSeating System Positioning Belts Positioning BeltsLimited Warranty USA
Related manuals
Manual 28 pages 55.84 Kb