SECTION 10—BATTERIES/CHARGER
Using the Proper Batteries
NOTE: For this procedure, refer to FIGURE 10.1.
1.Place battery on ground/flat surface.
2.Visually draw a horizontal and vertical centerline through the middle of battery (FIGURE 10.1).
3.Position the battery so that the terminals are above the horizontal centerline.
4.Visually inspect the battery to ensure the correct position of the POSITIVE and NEGATIVE terminals (FIGURE 10.1).
WARNING
Batteries with terminal configuration as shown below MUST be used. Batteries that have the reverse terminal configuration MUST NOT be used - otherwise injury and damage may occur.
The warranty and performance specifications contained in this manual are based on the use of deep cycle gel cell or sealed lead acid batteries. Invacare strongly recommends their use as the power source for this unit.
Use This Configuration | DO NOT Use | |
NEGATIVE |
|
|
| POSITIVE (+) | |
Battery Terminal |
| Battery Terminal |
|
|
|
NEGATIVE
Battery Terminal
U1 Battery | POSITIVE (+) | |
Battery Terminal | ||
| ||
| U1 Battery |
FIGURE 10.1 Using the Proper Batteries
Part No 1118377 | 87 | Pronto® M71™ |