SECTION 10—BATTERIES/CHARGER
8.Route the battery charger cable to the right side (from the rear of the wheelchair) of the battery charger body.
9.Connect the battery charge cable to the controller charger cable.
10.Using hook and loop strap provided, wrap the AC cord and secure to back of wheelchair.
11.Install the rear shroud. Refer to Removing/Installing the Shrouds on page 74.
12.Install the batteries. Refer to Installing Batteries on page 89.
Battery Charger Installed | Battery Charger Removed | ||
Battery Charger | AC Cord | Battery Charger | Hook and Loop Strips |
| |||
|
|
| |
| Battery |
|
|
| Charger |
| Wheelchair Frame |
| Cable |
| |
|
|
|
Hook and Loop Strap | Hook and |
|
Loop Strap |
| |
| ||
|
|
NOTE: Controller charger cable not shown.
FIGURE 10.7 Replacing the On-Board Battery Charger
Pronto® M71™ | 96 | Part No 1118377 |