Invacare M71 service manual Removing/Installing the Joystick, Van Seat Models

SECTION 11—CONTROLLER AND JOYSTICK

•On Wheelchair with SPJ-80,MPJ or DPJ Joystick - Align the joystick connector with the controller connector and secure using the thumb screws on the joystick connector (Detail “C” of FIGURE 11.1).

•On Wheelchairs with MPJ+ - Ensure the latch is pulled away from the joystick connector; connect the joystick connector to the other connectors, then push the latch in to secure the joystick connector to the other connectors (Detail “B” of FIGURE 11.1).

DETAIL “A”
Joystick Connector	DETAIL “C”
Controller
Connector	Joystick
Light GREY
Collar
DETAIL “B”	Thumb
Joystick	Screws
Connector	Joystick
	Connector
Latch
	Controller
Other	Connector
Connectors

NOTE: Only Van seat shown. Above procedure applies to all seats.

FIGURE 11.1 Disconnecting/Connecting the Joystick

Removing/Installing the Joystick

NOTE: If necessary, the joystick can be repositioned to the opposite armrest after being removed.

Van Seat Models

NOTE: For this procedure, refer to FIGURE 11.2 on page 99.

Removing

NOTE: Take note of position and orientation of mounting hardware for reinstalling the joystick assembly.

1. Cut two tie-wraps securing the joystick cable to the joystick mounting tube.

Pronto® M71™ 98 Part No 1118377