GE A071-0CG manual Baud Rate One Character Time ms

Page 18

	ANSI X3.28/SRIO DPA
GE Energy Services	CONFIGURATION GUIDE

NAME

RANGE

DESCRIPTION

	6 Digit BCD (6)	A typical value is 32 Bit Binary.
	3 Digit BCD (3)

Analog Scale	-32768 .. 32767	Returned to the master, but NOT USED !
		Default setting is 1000.

Timed Poll	-32768 .. 32767	Returned to the master to complete system partition, but NOT
Interval		USED by the ANSI software.
		Default setting is 30.

☞NOTE: The sequence of the data partitions listed above may not be altered, but the sizes

and start addresses may be changed at configuration time. For a complete detailed description of each data partition, refer to the ANSI X3.28/SRIO Functional Specification listed in the Additional Documentation section.

Baud Rate	One Character Time (ms)

300	34

600	17

1200	9

2400	5

4800	3

9600	2

Table 3 Character Times

☞NOTE: All character times in Table 3 are based on a 10-bit character, and are rounded up to the nearest millisecond.

A071-0CG-2.02-2Restricted

6	Full

Image 18

Contents Ansi X3.28/SRIO DPA Trademark Notices Table of Contents Ansi X3.28/SRIO DPA System Overview Xii Read Access Flags List of FiguresAnsi X3.28/SRIO DPA List of Tables Viii About this Guide Purpose of this GuideWho Should Use this Guide Additional Documentation Overview Product PerspectiveXii Configuring Tables Ansi X3.28/SRIO DPA Configuration TablesConfiguration Sequence Configuring the Main Table A071MAIN Character TimesAnsi X3.28/SRIO DPA GE Energy Services Baud Rate One Character Time ms Configuring the Mapping Tables Mapping Table Configuration Parameters Configuring Wesmaint for the Ansi X3.28/SRIO DPA Log-In User B014USERRead Access Flags Fatal Error Messages Appendix AError MessagesError Messages Ansi Application process diedCant create T071 exchange Cant allocate rx sinksCant create required exchanges. Suspending Cant get enough memory for Ansi Application. SuspendingCant spawn/activate E071 process Cant set communications timersCant set configured bit rate Cant spawn/activate L071 processInvalid AO offset configured Invalid AI offset configuredInvalid Analog Format configured 32 BIN, 6 or 3 BCD Invalid checksum configured Bcc or CrcInvalid do offset configured Invalid DD offset configuredInvalid DI offset configured Invalid embedded response enable Yes or NoInvalid modem enable Yes or No Invalid Evnt offset configuredInvalid EV offset configured Invalid OBJ offset configuredInvalid Retransmit analog configured -1 to Invalid parity configured None, Even, OddInvalid PD offset configured Invalid Retransmit digital configured -1 toMapped AI point not Found. Check config Invalid SYS offset configuredInvalid TM offset configured Mapped AO point not Found. Check configMapped EV point not Found. Check config Mapped DI point not Found. Check configMapped do point not Found. Check config Missing Configuration ... DeletingAnsi X3.28/SRIO DPA Glossary of Terms AsciiWIN List of Acronyms and Abbreviations