GE A071-0CG Cant set communications timers, Cant set configured bit rate, Cant spawn R071 process

Page 25

ANSI X3.28/SRIO DPA
CONFIGURATION GUIDE	GE Energy Services

Can't set communications timers

Cause:

•The system was unable to configure the port timers.

Remedy:

•Contact the Customer Service Department to report this error.

Can't set configured bit rate

Cause:

•The system was unable to initialize the port using the configured baud rate.

Remedy:

•Refer to the chapter entitled Configuring the Main Table (A071MAIN) and ensure the configured baud rate is valid.

Can't spawn/activate E071 process

Cause:

•The system cannot create the Event handler process.

Remedy:

•Contact the Customer Service Department to report this error.

Can't spawn/activate L071 process

Cause:

•The system cannot create the LRU process.

Remedy:

•Contact the Customer Service Department to report this error.

Can't spawn R071 process

Cause:

•The system cannot create the Receiver process.

Remedy:

•Contact the Customer Service Department to report this error.

Can't spawn T071 process

Cause:

•The system cannot create the Transmitter process.

Remedy:

•Contact the Customer Service Department to report this error.

Restricted

A071-0CG-2.02-2

Full	13

Image 25

Contents Ansi X3.28/SRIO DPA Trademark Notices Table of Contents Ansi X3.28/SRIO DPA List of Figures System Overview Xii Read Access FlagsAnsi X3.28/SRIO DPA List of Tables Viii Purpose of this Guide About this GuideWho Should Use this Guide Additional Documentation Product Perspective OverviewXii Ansi X3.28/SRIO DPA Configuration Tables Configuring TablesConfiguration Sequence Character Times Configuring the Main Table A071MAINAnsi X3.28/SRIO DPA GE Energy Services Baud Rate One Character Time ms Configuring the Mapping Tables Mapping Table Configuration Parameters Log-In User B014USER Configuring Wesmaint for the Ansi X3.28/SRIO DPARead Access Flags Error Messages Appendix AError MessagesFatal Error Messages Ansi Application process diedCant create required exchanges. Suspending Cant allocate rx sinksCant create T071 exchange Cant get enough memory for Ansi Application. SuspendingCant set configured bit rate Cant set communications timersCant spawn/activate E071 process Cant spawn/activate L071 processInvalid Analog Format configured 32 BIN, 6 or 3 BCD Invalid AI offset configuredInvalid AO offset configured Invalid checksum configured Bcc or CrcInvalid DI offset configured Invalid DD offset configuredInvalid do offset configured Invalid embedded response enable Yes or NoInvalid EV offset configured Invalid Evnt offset configuredInvalid modem enable Yes or No Invalid OBJ offset configuredInvalid PD offset configured Invalid parity configured None, Even, OddInvalid Retransmit analog configured -1 to Invalid Retransmit digital configured -1 toInvalid TM offset configured Invalid SYS offset configuredMapped AI point not Found. Check config Mapped AO point not Found. Check configMapped do point not Found. Check config Mapped DI point not Found. Check configMapped EV point not Found. Check config Missing Configuration ... DeletingAnsi X3.28/SRIO DPA Ascii Glossary of TermsWIN List of Acronyms and Abbreviations