GE A071-0CG manual Configuring the Mapping Tables

Page 19

Chapter 3: Configuring the Mapping Tables

The ANSI X3.28/SRIO DPA mapping tables specify the data to be placed in the corresponding data partition. This data will be returned to the master station in response to a read command for those partitions. Not all data partitions require a data-mapping table.

The ANSI X3.28/SRIO DPA contains the following mapping tables:

•Digital Input Map Table, A071DIMP

•Digital Output Map Table, A071DOMP

•Event Data Map Table, A071EVMP

•Analog Input Map Table, A071AIMP

•Analog Output Map Table, A071AOMP

Each of the mapping tables contains the same configuration parameter, and are configured in the same way.

☞NOTE: The SPABUS DCA Item Table, A070ITEM, must be configured before the ANSI X3.28/SRIO DPA mapping tables can be configured.

Restricted

A071-0CG-2.02-2

Full	7

Image 19

Contents Ansi X3.28/SRIO DPA Trademark Notices Table of Contents Ansi X3.28/SRIO DPA List of Figures System Overview Xii Read Access FlagsAnsi X3.28/SRIO DPA List of Tables Viii Purpose of this Guide About this GuideWho Should Use this Guide Additional Documentation Product Perspective OverviewXii Ansi X3.28/SRIO DPA Configuration Tables Configuring TablesConfiguration Sequence Character Times Configuring the Main Table A071MAINAnsi X3.28/SRIO DPA GE Energy Services Baud Rate One Character Time ms Configuring the Mapping Tables Mapping Table Configuration Parameters Log-In User B014USER Configuring Wesmaint for the Ansi X3.28/SRIO DPARead Access Flags Ansi Application process died Appendix AError MessagesError Messages Fatal Error MessagesCant get enough memory for Ansi Application. Suspending Cant allocate rx sinksCant create required exchanges. Suspending Cant create T071 exchangeCant spawn/activate L071 process Cant set communications timersCant set configured bit rate Cant spawn/activate E071 processInvalid checksum configured Bcc or Crc Invalid AI offset configuredInvalid Analog Format configured 32 BIN, 6 or 3 BCD Invalid AO offset configuredInvalid embedded response enable Yes or No Invalid DD offset configuredInvalid DI offset configured Invalid do offset configuredInvalid OBJ offset configured Invalid Evnt offset configuredInvalid EV offset configured Invalid modem enable Yes or NoInvalid Retransmit digital configured -1 to Invalid parity configured None, Even, OddInvalid PD offset configured Invalid Retransmit analog configured -1 toMapped AO point not Found. Check config Invalid SYS offset configuredInvalid TM offset configured Mapped AI point not Found. Check configMissing Configuration ... Deleting Mapped DI point not Found. Check configMapped do point not Found. Check config Mapped EV point not Found. Check configAnsi X3.28/SRIO DPA Ascii Glossary of TermsWIN List of Acronyms and Abbreviations