GE A071-0CG manual Configuring Tables, Ansi X3.28/SRIO DPA Configuration Tables

Page 13

Chapter 1: Configuring Tables

The ANSI X3.28/SRIO DPA configuration contains all of the data structures necessary to configure a RTU to communicate with an ANSI X3.28 master station.

1.1ANSI X3.28/SRIO DPA Configuration Tables

The purpose of each configuration table is in Table 1.

TABLE NAME	DESCRIPTION

A071MAIN	This table configures each communication port in the system and the database table addressing
	associated with it. The database table mapping allows the user to configure the default locations
	for the data partitions.

A071DIMP	This table defines the digital input items, which are to be reported back to the host station.

A071DOMP	This table defines the digital output items, which are to be reported back to the host station.

A071EVMP	This table defines the event items, which are to be reported back to the host station.

A071AIMP	This table defines the analog input items, which are to be reported back to the host station.

A071AOMP	This table defines the analog output items, which are to be reported back to the host station.


	Table 1 ANSI X3.28/SRIO DPA Configuration Tables

☞NOTE: The map tables are directly based on the SPABUS DCA. Points are

mapped into the ANSI X3.28 DPA based on the ITEM table created in the SPABUS configuration. The user must cross-reference the SPABUS ITEM table to ensure compatible data is mapped.

Restricted

A071-0CG-2.02-2

Full	1

Image 13

Contents Ansi X3.28/SRIO DPA Trademark Notices Table of Contents Ansi X3.28/SRIO DPA List of Figures System Overview Xii Read Access FlagsAnsi X3.28/SRIO DPA List of Tables Viii Purpose of this Guide About this GuideWho Should Use this Guide Additional Documentation Product Perspective OverviewXii Ansi X3.28/SRIO DPA Configuration Tables Configuring TablesConfiguration Sequence Character Times Configuring the Main Table A071MAINAnsi X3.28/SRIO DPA GE Energy Services Baud Rate One Character Time ms Configuring the Mapping Tables Mapping Table Configuration Parameters Log-In User B014USER Configuring Wesmaint for the Ansi X3.28/SRIO DPARead Access Flags Error Messages Appendix AError MessagesFatal Error Messages Ansi Application process diedCant create required exchanges. Suspending Cant allocate rx sinksCant create T071 exchange Cant get enough memory for Ansi Application. SuspendingCant set configured bit rate Cant set communications timersCant spawn/activate E071 process Cant spawn/activate L071 processInvalid Analog Format configured 32 BIN, 6 or 3 BCD Invalid AI offset configuredInvalid AO offset configured Invalid checksum configured Bcc or CrcInvalid DI offset configured Invalid DD offset configuredInvalid do offset configured Invalid embedded response enable Yes or NoInvalid EV offset configured Invalid Evnt offset configuredInvalid modem enable Yes or No Invalid OBJ offset configuredInvalid PD offset configured Invalid parity configured None, Even, OddInvalid Retransmit analog configured -1 to Invalid Retransmit digital configured -1 toInvalid TM offset configured Invalid SYS offset configuredMapped AI point not Found. Check config Mapped AO point not Found. Check configMapped do point not Found. Check config Mapped DI point not Found. Check configMapped EV point not Found. Check config Missing Configuration ... DeletingAnsi X3.28/SRIO DPA Ascii Glossary of TermsWIN List of Acronyms and Abbreviations