GE A071-0CG manual Configuring Wesmaint for the Ansi X3.28/SRIO DPA, Log-In User B014USER

Page 21

Chapter 4: Configuring WESMAINT for the ANSI X3.28/SRIO DPA

This chapter describes how to configure the WESMAINT application to allow ANSI X3.28/SRIO DPA user's access to the ANSI X3.28/SRIO DPA custom WESMAINT screens.

4.1Log-In User (B014USER)

B014USER contains WESMAINT application access information for individual users. The B014USER table is part of the WESMAINT configuration, B014, and is mentioned here for completeness only. It is not part of the ANSI X3.28/SRIO DPA configuration, but must be configured if any of the desired options are required for the ANSI X3.28/SRIO DPA custom WESMAINT menus.

The application control parameters in B014USER are used to provide users access to the ANSI X3.28/SRIO DPA custom WESMAINT screens. The first application control parameter is the application number. For control of the ANSI X3.28/SRIO DPA it must always be 71. The second parameter is the modify access flag and the third is the read- access flag. A description of the read flags used by the ANSI X3.28/SRIO DPA is shown in Figure 2. All unmarked bits are unused, and should be set to zero. The ANSI X3.28/SRIO DPA does not use any of the modify access flags.

Restricted

A071-0CG-2.02-2

Full	9

Image 21

Contents Ansi X3.28/SRIO DPA Trademark Notices Table of Contents Ansi X3.28/SRIO DPA List of Figures System Overview Xii Read Access FlagsAnsi X3.28/SRIO DPA List of Tables Viii About this Guide Purpose of this GuideWho Should Use this Guide Additional Documentation Product Perspective OverviewXii Ansi X3.28/SRIO DPA Configuration Tables Configuring TablesConfiguration Sequence Character Times Configuring the Main Table A071MAINAnsi X3.28/SRIO DPA GE Energy Services Baud Rate One Character Time ms Configuring the Mapping Tables Mapping Table Configuration Parameters Log-In User B014USER Configuring Wesmaint for the Ansi X3.28/SRIO DPARead Access Flags Error Messages Appendix AError MessagesFatal Error Messages Ansi Application process diedCant create required exchanges. Suspending Cant allocate rx sinksCant create T071 exchange Cant get enough memory for Ansi Application. SuspendingCant set configured bit rate Cant set communications timersCant spawn/activate E071 process Cant spawn/activate L071 processInvalid Analog Format configured 32 BIN, 6 or 3 BCD Invalid AI offset configuredInvalid AO offset configured Invalid checksum configured Bcc or CrcInvalid DI offset configured Invalid DD offset configuredInvalid do offset configured Invalid embedded response enable Yes or NoInvalid EV offset configured Invalid Evnt offset configuredInvalid modem enable Yes or No Invalid OBJ offset configuredInvalid PD offset configured Invalid parity configured None, Even, OddInvalid Retransmit analog configured -1 to Invalid Retransmit digital configured -1 toInvalid TM offset configured Invalid SYS offset configuredMapped AI point not Found. Check config Mapped AO point not Found. Check configMapped do point not Found. Check config Mapped DI point not Found. Check configMapped EV point not Found. Check config Missing Configuration ... DeletingAnsi X3.28/SRIO DPA Ascii Glossary of TermsWIN List of Acronyms and Abbreviations