GE A071-0CG manual Configuration Sequence

Page 14

 

ANSI X3.28/SRIO DPA

GE Energy Services

CONFIGURATION GUIDE

1.2Configuration Sequence

The following is a list of the steps required to configure the ANSI X3.28/SRIO DPA:

1.Edit the configuration for the other applications that will run on the product. Prepare them according to their own configuration guides. The SPABUS DCA must be configured before the ANSI X3.28/SRIO DPA.

2.Edit the ANSI X3.28/SRIO DPA configuration. Prepare it according to the guidelines in this document and the specific use for which the ANSI X3.28/SRIO DPA is required.

3.Generate the configuration and download it to the product using a GE Energy Services Configuration System. The list of applications to be compiled must include the ANSI X3.28/SRIO DPA, application A071, and the SPABUS DCA, application A070.

4.Restart the product. If the ANSI X3.28/SRIO DPA encounters an error during its initialization, it will log a message to the WESMAINT Error Log and then, depending on the severity of the error, terminate or continue with its run-time function.

5.Check for error messages. Log into the WESMAINT maintenance interface, select the SYSTEM FUNCTIONS item from the Main Menu, and then select the ERROR LOG item from the System Functions Menu. If any error messages are displayed, correct the problem as described in Appendix B: ERROR MESSAGES, and repeat steps 3 through 5.

When the ANSI X3.28/SRIO DPA has successfully validated all the configuration parameters, configuration is complete.

A071-0CG-2.02-2Restricted

2

Full

 

Image 14
Contents Ansi X3.28/SRIO DPA Trademark Notices Table of Contents Ansi X3.28/SRIO DPA System Overview Xii Read Access Flags List of FiguresAnsi X3.28/SRIO DPA List of Tables Viii Who Should Use this Guide About this GuidePurpose of this Guide Additional Documentation Overview Product PerspectiveXii Configuring Tables Ansi X3.28/SRIO DPA Configuration TablesConfiguration Sequence Configuring the Main Table A071MAIN Character TimesAnsi X3.28/SRIO DPA GE Energy Services Baud Rate One Character Time ms Configuring the Mapping Tables Mapping Table Configuration Parameters Configuring Wesmaint for the Ansi X3.28/SRIO DPA Log-In User B014USERRead Access Flags Fatal Error Messages Appendix AError MessagesError Messages Ansi Application process diedCant create T071 exchange Cant allocate rx sinksCant create required exchanges. Suspending Cant get enough memory for Ansi Application. SuspendingCant spawn/activate E071 process Cant set communications timersCant set configured bit rate Cant spawn/activate L071 processInvalid AO offset configured Invalid AI offset configuredInvalid Analog Format configured 32 BIN, 6 or 3 BCD Invalid checksum configured Bcc or CrcInvalid do offset configured Invalid DD offset configuredInvalid DI offset configured Invalid embedded response enable Yes or NoInvalid modem enable Yes or No Invalid Evnt offset configuredInvalid EV offset configured Invalid OBJ offset configuredInvalid Retransmit analog configured -1 to Invalid parity configured None, Even, OddInvalid PD offset configured Invalid Retransmit digital configured -1 toMapped AI point not Found. Check config Invalid SYS offset configuredInvalid TM offset configured Mapped AO point not Found. Check configMapped EV point not Found. Check config Mapped DI point not Found. Check configMapped do point not Found. Check config Missing Configuration ... DeletingAnsi X3.28/SRIO DPA Glossary of Terms AsciiWIN List of Acronyms and Abbreviations