GE A071-0CG Invalid Evnt offset configured, Invalid EV offset configured, Invalid Number of Enqs

Page 28

	ANSI X3.28/SRIO DPA
GE Energy Services	CONFIGURATION GUIDE

Invalid EVNT offset configured

Cause:

•The configured event partition offset is invalid.

Remedy:

•Ensure the configured EVNT Offset in A071MAIN is a positive value.

•Ensure the configured EVNT Offset is less than the DD Offset.

Invalid EV offset configured

Cause:

•The configured event storage partition offset is invalid.

Remedy:

•Ensure the configured EV Offset in A071MAIN is a positive value.

•Ensure the configured EV Offset is less than the AI Offset.

Invalid modem enable (Y)es or (N)o

Cause:

•The configured modem enable parameter is invalid.

Remedy:

•Ensure the configured Modem Enabled parameter in A071MAIN is either Yes (Y) or No (N).

Invalid Number of ENQS

Cause:

•The configured number of ENQs to be re-transmitted is invalid.

Remedy:

•Ensure the configured ENQ Count in A071MAIN is a positive number.

Invalid Number of NAKS

Cause:

•The configured number of ENQs to be re-transmitted is invalid.

Remedy:

•Ensure the configured ENQ Count in A071MAIN is a positive number.

Invalid OBJ offset configured

Cause:

•The configured object partition offset is invalid.

Remedy:

•Ensure the configured Obj Offset in A071MAIN is a positive value.

•Ensure the configured Obj Offset is less than 27000.

A071-0CG-2.02-2Restricted

16	Full

Image 28

Contents Ansi X3.28/SRIO DPA Trademark Notices Table of Contents Ansi X3.28/SRIO DPA System Overview Xii Read Access Flags List of FiguresAnsi X3.28/SRIO DPA List of Tables Viii Purpose of this Guide About this GuideWho Should Use this Guide Additional Documentation Overview Product PerspectiveXii Configuring Tables Ansi X3.28/SRIO DPA Configuration TablesConfiguration Sequence Configuring the Main Table A071MAIN Character TimesAnsi X3.28/SRIO DPA GE Energy Services Baud Rate One Character Time ms Configuring the Mapping Tables Mapping Table Configuration Parameters Configuring Wesmaint for the Ansi X3.28/SRIO DPA Log-In User B014USERRead Access Flags Appendix AError Messages Error MessagesFatal Error Messages Ansi Application process diedCant allocate rx sinks Cant create required exchanges. SuspendingCant create T071 exchange Cant get enough memory for Ansi Application. SuspendingCant set communications timers Cant set configured bit rateCant spawn/activate E071 process Cant spawn/activate L071 processInvalid AI offset configured Invalid Analog Format configured 32 BIN, 6 or 3 BCDInvalid AO offset configured Invalid checksum configured Bcc or CrcInvalid DD offset configured Invalid DI offset configuredInvalid do offset configured Invalid embedded response enable Yes or NoInvalid Evnt offset configured Invalid EV offset configuredInvalid modem enable Yes or No Invalid OBJ offset configuredInvalid parity configured None, Even, Odd Invalid PD offset configuredInvalid Retransmit analog configured -1 to Invalid Retransmit digital configured -1 toInvalid SYS offset configured Invalid TM offset configuredMapped AI point not Found. Check config Mapped AO point not Found. Check configMapped DI point not Found. Check config Mapped do point not Found. Check configMapped EV point not Found. Check config Missing Configuration ... DeletingAnsi X3.28/SRIO DPA Glossary of Terms AsciiWIN List of Acronyms and Abbreviations