Philips HX6902, HX6942, HX6983, HX6985 Quadpacer, Cord wrap on deluxe charger specific types only

English 

Quadpacer

1

2

4 3

-The Quadpacer is an interval timer that has a short beep and pause to remind you to brush the 4 sections of your mouth. Depending on the brushing mode or brushing routine you have selected, the Quadpacer beeps at different intervals during the brushing cycle. See the ‘Brushing

instructions’ and ‘Personalising your brushing experience’ sections. The Quadpacer on this model has been activated.To deactivate or reactivate the Quadpacer:

1Place the handle with a brush head attached on the plugged-in charger or sanitiser

2To deactivate the Quadpacer: press and hold the Personalised Brushing button for 5 seconds.You hear 1 beep to indicate that the Quadpacer has been deactivated.

,To reactivate the Quadpacer: press and hold the Personalised Brushing button for 5 seconds until you hear 2 beeps.This indicates that the Quadpacer is active again.

Note:The Quadpacer cannot be deactivated on the pre-programmed Go Care and Max Care brushing routines.

Cord wrap on deluxe charger (specific types only)

If your model includes the deluxe charger cover and base, the travel charger is pre-installed inside the cover. If you want to shorten the mains cord, you can store excess cord in the cord-wrap feature built into the charger base.

1To separate the charger cover from the charger base, press the two grey snap bars on the charger base and pull the white charger cover upwards.

2Wrap excess cord around the grey charger base as shown in the picture. Be sure to wrap the cord on the inside of the two snap levers.

3When you have stored the excess cord, guide the cord through the small groove in the rear of the grey charger base.

4Reattach the charger cover by pressing it down over the charger base until it snaps into place.

Tip: For extra convenience during travel, you can remove the travel charger and use it without the charger cover and charger base.