PROCEDURE 5 | CASTERS |
C A S T E R S
REPLACING/REPAIRING FRONT CASTER TIRE/TUBE
WARNING
Replacement of front caster tire or tube MUST be performed by an authorized Invacare dealer or qualified technician.
CAUTION
As with any vehicle, the wheels and tires should be checked periodically for cracks and wear, and should be replaced when necessary.
90o ADJUSTMENT OF THE CASTER HEADTUBES
Whenever the seat height is raised or lowered by changing the caster size, fork stem length, rear wheel size or axle mounting plate adjustments, the caster headtube needs to be checked to maintain a 90o angle to the ground/floor. Caster headtubes that are per- pendicular to the floor will roll better, track straighter and minimize any
Inline Caster Headtubes (FIGURE 3)
1.Make sure the wheelchair is on a flat surface.
2.Loosen, but do not remove the bottom hex screw, washer and locknut that secure the caster headtube to the wheelchair frame.
3.Loosen, but do not remove the locknut and washer that secure the adjustment cam to the caster headtube.
4.Position a large right triangle or "L" square on the flat surface and against the caster headtube.
5.Move the caster headtube back and forth until the caster headtube is perpendicular to the ground/ floor.
6.While holding the caster headtube perpendicular to the ground/floor, securely tighten the adjustment cam to the caster headtube.
7.Make sure the caster headtube is still perpendicu- lar to the ground/floor by placing the large right triangle or "L" square on the flat surface and against the caster headtube.
8.Securely tighten the hex bolt, washer and locknut that secure the caster headtube to the wheelchair frame.
Offset Caster Headtubes (FIGURE 4)
1.Make sure the wheelchair is on a flat surface.
2.Loosen, but do not remove the bottom socket bolt, washer and locknut that secure the caster headtube to the wheelchair frame.
3.Remove the TOP washer and locknut that secure the adjustment cam to the caster headtube.
4.Remove the adjustment cam from the caster headtube.
5.Position a large right triangle or "L" square on the flat surface and against the caster headtube.
6.Move the caster headtube back and forth until the caster headtube is perpendicular to the ground/ floor.
7.Reinstall the adjustment cam onto the TOP socket screw that secures the adjustment cam to the caster headtube.
|
| Caster Headtube |
| Caster/Fork | "L" Square |
Adjustment Cam |
| |
|
| |
Caster Headtube | Caster Headtube | Adjustment Cam |
|
Caster/Fork
Channel
"L" Square
FIGURE 3 - INLINE CASTER HEADTUBES | FIGURE 4 - OFFSET CASTER HEADTUBES |
42