Invacare 1061057, 96-100 manual Handrim Replacement Figure, Removing the Play From the Rear Wheels

Page 47

REAR WHEELS

PROCEDURE 6

WARNING

Make sure the detent pin and locking pins of the quad-release axle are fully released BEFORE op- erating the wheelchair.

Keep locking pins clean.

6.Flip the handle of the quad-release axle down to release the detent pin ensuring that the locking pins are fully released.

7.Repeat the above procedures until the quad-re- lease axle locks correctly.

Removing the Play From the Rear Wheels

NOTE: The adjusting nut on the quick-release ax- les originally performed this function.

1.With the rear wheel and quad-release axle still mounted onto the wheelchair, make the following adjustment:

Tighten the length adjusting screw until there is no in and out movement of the quad-release axle and rear wheel.

HANDRIM REPLACEMENT (FIGURE 5)

Spoke Rear Wheels

1.Remove the rear wheel from the wheelchair. Re- fer to REMOVING/INSTALLING REAR WHEELS in this section of the manual.

WARNING

Tire MUST be deflated before any disassembly procedures are performed.

2.Remove all air from the bar by pressing down on the pin in the center of the valve stem.

3.While carefully holding the tire, bar and rim strip to one side, hold the phillips bolts and remove the locknuts that secure the handrim to the rear wheel.

4.Remove the existing handrim.

5.Install the new handrim by reversing the above procedures.

WARNING

DO NOT inflate tire until it is completely assembled.

6.Inflate the tire to the correct psi rating on the sidewall of the tire.

WARNING

Make sure detent pin and locking pins of the quick/quad-release axles are fully released BE- FORE operating the wheelchair.

7.Reinstall rear wheel to the wheelchair. Refer to REMOVING/INSTALLING REAR WHEELS in this section of the manual.

8.If the locking pins of the quick/quad-release axles are not protruding past the inside of the axle bush- ing or there is too much movement of the rear wheel assembly in a back and forth position, refer to ADJUSTING THE QUICK-RELEASE AXLE or ADJUSTING THE QUAD-RELEASE HANDLE in this section of the manual.

9.Repeat the procedure for the opposite rear wheel if necessary.

Phillips

Bolt

Handrim

SPOKE

REAR

WHEELS

Locknut

COMPOSITE

Button Screw

REAR

 

WHEELS

 

Handrim

FIGURE 5 - HANDRIM REPLACEMENT

Composite Rear Wheels

1.Remove the rear wheel from the wheelchair. Re- fer to REMOVING/INSTALLING REAR WHEELS in this section of the manual.

2.Remove the button screws and washers that se- cure the handrim to the rear wheel.

3.Remove the existing handrim.

4.Install the new handrim by reversing the above procedures.

WARNING

Make sure detent pin and locking pins of the quick/quad-release axles are fully released BE- FORE operating the wheelchair.

R E A R

W

H

E

E

L

S

47

Page 46 Page 48
Image 47
Page 46 Page 48
Contents Allegro Special Notes Special NotesTable of Contents Safety Summary Safety SummaryRecliner Option only Safety SummarySAFETY/HANDLING of Wheelchairs Transferring to and from Other Seats StairwaysRecliners Percentage of Weight DistributionUnoccupied Occupied NON-RECLINERSBending Forward SAFETY/HANDLING Functional Reach from a WheelchairFolding and Unfolding Wheelchair Solid Seat Model Wheelchairs Recliners onlySling Seat Model Wheelchairs Unfolding Folding Sling Seat Model Wheelchairs FoldingA T U R E S FeaturesFeatures Specifications SpecificationsN D L I N G PackagingHandling C K a G I N GSafety Inspection Check List Safety Inspection ChecklistI N T E N a N C E TroubleshootingMaintenance Pivot Slide Tube Height Adjustment Figure Procedure Front RiggingsInstalling Footrests Figure Adjusting Footrest HeightRaising/Lowering Elevating Legrests Installing 3-INCH Extension FigureInstalling Elevating Legrests Figure ProcedureAdjustable Angle Flip-up Footplate Depth Adjustment Figure Adjusting CalfpadsINSTALLING/ADJUSTING Adjustable Angle FLIP-UP Footplates Installing Adjustable Angle Flip-up Footplates FigureAluminum or Composite Footplates Figure Optional Footrest AccessoriesReplacing Sector Block Figure FLIP-UP Footplates FigureM S Procedure ArmsInstalling Width Figure Adjusting the T ArmsRemoving Height FigureArm Hex Screws Washers Reposition the arm tube on the T arm postArm Sockets Figure Socket Screws Bottom Clamp Arms ProcedureReplacing the Locking Lever T Arms Figure Top Middle Bottom Side Arm GuardCorresponding Arm Adjustment to Back Angle Figures 10 Using FigureInstalling/Height Adjustment Figure Locking Mechanism Actuator Apply Loctite AdjustmentReplacement Angled Portion Cantilever ArmRemoving Conventional Arms Installing Fabric Clothing Guards FigureAdjusting Conventional Arm Height Installing Rigid Side Guards FigureFront Arm Sockets Figure Replacing Armrest Pads FigureRear Arm Sockets Figure Replacing Back Upholstery Procedure BackInstalling Adjustable Back Upholstery Figure C KAdjustable Tension Straps Replacing Adjustable Back Upholstery FigureBack upholstery cover is designed for three 3 reasons WHY USE Adjustable Back Upholstery a Clinical DiscussionBack Upholstery Cover Recliner Headrest Upholstery Figure Adjusting the Back HeightAdjustable Height Backs Figure Recliner Back Upholstery FigureBack Cane Hex Bolt Washer Back Angle Plate Locknut Fixed Height Backs FigureSlowly remove the two 2 backs canes from the wheelchair Replacing the Locking Mechanism in the Back Cane Figure Non-Recliners Figure Changing the Back AngleRepositioning the Back Changing Seat Depth Back PlateRecliners Figure Back Angle Plate Hex Bolt Locknut Wheelchair Frame WasherReplacing Folding Push Handle Recliners only Figure Installing and Removing a Seating SystemRecliner Brackets Replacing Seat Upholstery Figure A TSeat CHANGING/REPOSITIONING Seat Rails FigureStandard Folding Frames Figure Procedure SeatRepositioning the Crossbraces Figure Changing Seat WidthFolding Frames Without Seat Rails Figure For installation of newPivot Link CrossbracesCrossmembers Wheelchair Frame Washer Hex Screws Hex Bolt Seat Width HolesRigid Frames Figure Replacing Front Fork Figure S T E R SCasters Offset Caster Headtubes Figure REPLACING/REPAIRING Front Caster TIRE/TUBECasters Inline Caster Headtubes FigureInline Caster Headtube Hardware Offset Caster Headtube Mounting Adjustments FigureHeight Adjustment Repositioning the Caster HeadtubesCover Headtube Locknut Cap Spacer Fork Stem Hex Screw Installing QUICK-RELEASE Casters FigureDust Release Detent Pin Rear Wheels REMOVING/INSTALLING Rear Wheels FigureAdjusting the QUICK-RELEASE Axle Figure A RAnd/or Out Installing the QUAD-RELEASE Axle FigureAdjusting the QUAD-RELEASE Handle Figure Justing the QUAD-RELEASE HandlePhillips Bolt Handrim Handrim Replacement FigureRemoving the Play From the Rear Wheels Spoke Rear WheelsSpoke Rear Wheels Figure Installing Projection HandrimsComposite Rear Wheels Figure Composite Rim LocknutShortening Forward REPAIRING/REPLACING Rear Wheel TIRE/ TubeAdjusting the Wheelbase Length Figure Jam NutsMounting Plate Adjusting the Wheelbase Width FigureAdjusting Rear Wheel Height Figure AxleWheel LOCKS/ANTI-TIPPERS Adjusting the Wheel Locks FigureWheel Lock Extension Handle Installation Figure E E L K S E R SInstalling the Anti-Tippers Figure Procedure Wheel LOCKS/ANTI-TIPPERSINSTALLING/ADJUSTING the ANTI-TIPPERS Adjusting the Anti-Tippers FigureFolding/Unfolding the Wheelchair REPLACEMENT/ADJUSTMENTRecliner Recliner Operation Figures 1Trigger Release Lever Installing New Recliner CablesActuator Housing Cable Locking Nut ReclinerSteps 1, 5 Replacing the GAS Cylinders FigureMust Look TOO LOW Like thisDetail B Must Look TOO LOW Adjusting the GAS Cylinders FigureTrigger Release Lever Cable Locking Nut Adjusting Squeeze the handles to extend the new gas cylindersEquals SEAT-TO-FLOORSEAT-TO-FLOOR Height Determination MinusStandard MULTI-POSITION Axle Plate Procedure SEAT-TO-FLOORChanging SEAT-TO-FLOOR Height A T Frame Inline Caster Headtube Front SEAT-TO-FLOOR HeightsLower Offset Caster Headtube Front SEAT-TO-FLOOR Heights Seat Depth A T P T HSeat Depth Determination Figure Changing Seat DepthSeat Depth Seat Depth ChecklistRear Mounting Hole A T P TLeft RightApproximate 2-inch gap A T P T Inch Right A T P T H Page R R a N T Y Limited WarrantyLimited Warranty One Invacare Way Technical Support
Top Page Image Contents